Venstar SEN6 Wi-Fi Temperature Sensor User Manual

Venstar Inc Wi-Fi Temperature Sensor

User Manual

OVERVIEWThis Wi-Fi module is intended to be used with a compatible Venstar thermostat. Please consult Venstar.com for a complete listing of compatible thermostats. model: ACC-TSENWIFITemperature Sensor with Wi-Fi Installation InstructionsBefore you begin the Installation:Select a suitable location for the ACC-TSENWIFI sensor. Please note that it must have good Wi-Fi reception from the access point it is intended to join.The Venstar Congurator App is needed to congure this sensor. This App may be downloaded from your mobile device store.Please have handy the manual for the thermostat that will be paired with the sensor. Each line of thermostats has unique pairing procedures.Each model thermostat has unique features in regards to averaging more than one ACC-TSENWIFI sensor. Please consult the thermostat manual to learn the thermostat’s capabilities and setup procedure.This sensor is compatible with all Venstar Wi-Fi thermostats with the latest rmware. To Connect the Sensor to an Access Point:1. Congure the Sensor a. Set the Type: i . Outdoor temperature is sampled and transmitted once every 5 minutes. ii. Return temperature is sampled and transmitted once every 20 seconds. 1. Must be connected to 24Vac for 20 second sample rate. If battery powered; 1 minute sample rate. iii. Remote temperature is sampled and transmitted once every 5 minutes. iv. Supply temperature is sampled and transmitted once every 20 seconds. 1. Must be connected to 24Vac for the 20 second sample rate. If battery powered; 1 minute sample rate. b. Set the Unit ID: If more than 1) ACC-TSENWIFI is joined to an access point each sensor will have to have a unique ID#. Up to 20 ACC-TSENWIFI sensors may be joined to 1 access point. c. Select the Temperature Sensor: i . Onboard will use the temperature sensor mounted on the circuit board of the ACC-TSENWIFI. ii. Remote will use the sensor connected to the remote sensor terminals on the back of the ACC-TSENWIFI.2. Install 4 AA batteries with the polarity as indicated on the ACC-TSENWIFI housing. (Disregard the battery installation when connecting to 24Vac) a. Alkaline batteries are acceptable for operation in the temperature range of xxF to xxF degrees. b. Below xxF degrees to xxF degrees it is recommended to use good quality Lithium AA batteries.3. Press and hold the Link button until the Link LED starts to ash.4. Use the Venstar Congurator App to setup the Wi-Fi connection. a. The LED will stay solid when connecting to the access point. b. If the connection is successful the LED will turn off. c. If the connection is unsuccessful the LED will blink 5 times. Pair to your thermostat:1. After successfully connecting the sensor to the access point, press the Link button of the sensor.2. Follow the thermostat’s instruction manual to setup the thermostat to ‘listen’ and pair to the sensor.

Navigation menu