Venture Global TFX-301 Wireless Telephone Signaler User Manual 3
Venture Global Limited Wireless Telephone Signaler 3
Manual
BATTERY INSTALLATION
zone you want to pair with.
Press melody selector to scroll through the melodies.
Once you hear the telephone sound, do not press
again as it is now selected.
Step 5: Once you have selected the zone and sound, press the
test button on the telephone signaler once. If successful,
the receiver will generate a short tone. Press the
button to exit pairing mode it is now ready to use.
+
CR2032
Test
Telephone Plug
RJ11
Battery
compartment Open the cover
The telephone signaler works with the receiver
(chime),
and must be paired prior to use.
Step 1: Insert battery to the telephone
transmitter.
Step 2: Insert batteries to the receiver
(chime).
Step 3: Enter pairing mode for receiver
(chime unit).
Press and hold the zone selector
button 3 seconds. The LED #1 will
flash.
Step 4: Press the button again to move to the
CODE MATCHING & MELODY SELECTION
ID
Zone selector
button
Melody
selector
CHI ME
LIG HT
LIG HT & CHIM E
OPERATION
CODE CONFLICT
If the telephone signaler coding is the same as another sensor you
must change the code. After you have changed the code re-
matching the telephone signaler.
+
+
CR2032
Open the cover Remove the battery
Press and hold the test button, insert
the battery whilst holding the button
for 5 seconds. The LED will flash 5 times
when a new code is generated
Plug the telephone line into the telephone socket as the diagram.
The system is ready to use.
PARTS & FUNCTION
USER MANUAL
FCC Statement:
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate
radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
* Reorient or relocate the receiving antenna.
* Increase the separation between the equipment and receiver.
* Connect the equipment to an outlet on a circuit different from that to which
the receiver is connected.
This device complies with part 15 of the FCC rules. Operation is subject to
the following two conditions: (1) This device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
Note: Modifications to this product will void the user's authority to
operate this equipment.