Verifone OMNI3600G Point of Sale Terminal User Manual
VeriFone Inc Point of Sale Terminal
Verifone >
Contents
- 1. FCC warning statement
- 2. installation guide page 1 to 18
- 3. installation guide page 19 to 45
- 4. users manual
FCC warning statement
VeriFone, Inc. 2455 Augustine Drive Santa Clara CA 95054-3002 Tel: 800-VeriFone (837-4366) www.verifone.com Omni 3600 Certifications and Regulations FCC Compliance Manufacturer: VeriFone, Inc. Separate Power Sources Model: Omni 3600 Some peripherals require a separate power source. Before connecting a check reader or similar device, turn off power to the terminal. FCC Part 15 Class B Peripherals This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Before connecting any peripheral device, turn off power to the terminal. Turn on power only after you are finished connecting the peripheral device(s). For complete information about peripheral installation and use, please refer to the user documentation supplied with those devices. Disconnecting Power SAR Labeling Mobitex USA Disconnecting power during a transaction may cause transaction data files that are not yet stored in terminal memory to be lost. Surge Protectors To protect your terminal against possible damage caused by lightning strikes and electrical surges, you may want to install a power surge protector. Location – Electrical Considerations CAUTION: Due to risk of electrical shock or terminal damage, do not use the terminal near water, including a bathtub, wash bowl, kitchen sink or laundry tub, in a wet basement, or near a swimming pool. Also, avoid using this product during electrical storms. To comply with the FCC RF exposure requirements, bystanders and parts of the users body other then the extremities must be at least 15.0mm away from the device. CDMA USA SAR compliance for body worn operating configurations is limited to the specific belt clips / holsters / accessories that have no metallic component in the assembly. The highest reported SAR values under this FCC ID are: AMPS/CDMA modes (Part 22) – Body-worn 0.0056mW/g. Brazil Avoid locations near electrical appliances or other devices that cause excessive voltage fluctuations or emit electrical noise (for example, air conditioners, neon signs, high-frequency or magnetic security devices, or electric motors). """O terminal Omni 3600 atende aos limites da Taxa de Absorção Específica referente à exposição a campos elécticos, magnéticos e electromagnéticos de radiofreqüências adoptados pela Anatel.""" Equipment GSM/GPRS Damage USA Carefully inspect the shipping carton and its contents for any damage. If the terminal or any product component appears damaged or tampered with, immediately notify the shipping company and your VeriFone distributor or service provider. SAR compliance for body worn operating configurations is limited to the specific belt clips / holsters / accessories that have no metallic component in the assembly. The highest reported SAR values under this FCC ID are: PMS modes (Part 22) – Body-worn 0.245mW/g, PCS mode (Part 24) - Body-worn: 0.218mW/g. CAUTION: Do not use a terminal that has been damaged or tampered with. Repairs Unless otherwise instructed in this document, do not, under any circumstances, attempt any service, adjustments, or repairs on this equipment. Instead, contact your local VeriFone distributor or service provider for assistance. Failure to comply may invalidate the product warranty. Location – Environmental Considerations Electrical LI-ion Battery Module—Rechargeable Battery Unit Caution Do not: • disassemble, crush, puncture, or incinerate in fire. • short circuit contacts. • expose to temperatures exceeding 140°F (60°C). Do not plug the power pack into an outdoor outlet or operate the terminal outdoors. It is not waterproof or dustproof, and is for indoor use only. Any damage to the unit from exposure to rain or dust may void your warranty. Power Packs Do not use the terminal where there is high heat, dust, humidity, moisture, or caustic chemicals or oils. Keep the terminal away from direct sunlight and anything that radiates heat, such as a stove or a motor. Before you connect the terminal power pack to an electrical outlet, check that the on/off power switch on the terminal is off. If the terminal does not have an on/off switch, check that the power cable connector is removed from the terminal’s power port. Cleaners and Solvents Never use thinner, trichloroethylene, or ketone-based solvents to clean the terminal — they may deteriorate plastic or rubber parts. Do not spray cleaners or other solutions directly onto the keypad or display. For best results, use a VeriFone Cleaning Kit or a clean cloth dampened with water and mild soap. To remove stubborn stains, use alcohol or an alcohol-based cleaner. or When connecting the terminal to a power pack, always connect the three-pronged plug of the power pack to an electrical wall outlet first. Then connect the power cable to the terminal’s power port. AC Adapter Location – Ease of Use The AC adapter is designed to ensure your personal safety and to be compatible with this equipment. Please follow these guidelines: Select a location for your terminal that contributes to its ease of use: • A location convenient for both merchant and cardholder. • A flat support surface, such as a countertop or table. • A location near a power outlet and a telephone/modem line connection. • • • WARNING! Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. Omni 3600 Certifications and Regulations VeriFone Part Number: 22475 Revision D 2003 VeriFone, Inc. All rights reserved. • • Do not use the adapter in a high moisture environment. Never touch the adapter when your hands or feet are wet. Allow adequate ventilation around the adapter. Avoid locations with restricted airflow. Connect the adapter to a proper power source. The voltage and grounding requirements are found on the product case and/or packaging. Do not use the adapter if the cord becomes damaged. Do not attempt to service the adapter. There are no serviceable parts inside. Replace the unit if it is damaged or exposed to excess moisture. continued Omni 3600 GPRS Declaration of Conformity Omni 3600 GSM Declaration of Conformity
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No Create Date : 2003:08:04 22:55:46Z Modify Date : 2003:08:04 15:56:44-07:00 Creator : Windows NT 4.0 Page Count : 2 Creation Date : 2003:08:04 22:55:46Z Mod Date : 2003:08:04 15:56:44-07:00 Producer : Acrobat Distiller 5.0.5 (Windows) Metadata Date : 2003:08:04 15:56:44-07:00 Title : Untitled DocumentEXIF Metadata provided by EXIF.tools