Verifone VX680WIFI Point of Sale Terminal User Manual 2 of 2

VeriFone Inc Point of Sale Terminal 2 of 2

Contents

user manual 2 of 2

 FCC Regulations:  15.19(a)(3): This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.  15.105(b): NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/ TV technician for help  Changes  or  modifications  not  expressly  approved  by  the  party  responsible  for compliance could void the user‘s authority to operate the equipment.  The antenna(s) used for this transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.
 RF Exposure Information (SAR)  This device meets the government’s requirements for exposure to radio waves. This  device  is  designed  and  manufactured  not  to  exceed  the  emission  limits  for exposure  to  radio  frequency  (RF)  energy  set  by  the  Federal  Communications Commission of the U.S. Government.      The  exposure  standard  employs  a  unit  of  measurement  known  as  the  Specific Absorption Rate, or SAR.    The SAR limit set by  the  FCC is  1.6W/kg.    Tests  for SAR are conducted using standard operating positions accepted by the FCC with the EUT transmitting at the specified power level in different channels.    The highest SAR value for the device as reported to the FCC is 0.000435 W/kg when placed next to the body.      The FCC has granted an Equipment Authorization for this device with all reported SAR levels evaluated as in compliance with the FCC RF exposure guidelines.    SAR information on this device is on file with the FCC and can be found under the Display Grant  section  of  www.fcc.gov/oet/ea/fccid  after  searching  on  FCC  ID: B32VX680WIFI.  This device is  compliance with SAR  for  general population /uncontrolled exposure limits  in  ANSI/IEEE  C95.1-1999  and  had  been  tested  in  accordance  with  the measurement methods and procedures specified in OET Bulletin 65 Supplement C.

Navigation menu