Verve Wireless ROXX RF Beacon User Manual
Verve Wireless, Inc. RF Beacon Users Manual
Users Manual
MODEL X v1.0 MANUAL
INTENDED USE
The Model X v1.0 Verve Beacon (the “beacon”) is a small, battery-
powered device that transmits a Bluetooth® low-energy (BLE) signal that
can be detected by other devices (e.g., smartphones or devices capable
of receiving the signal). This signal identifies the beacon and broadcasts
the ID to the receiving device.
The beacon works by periodically “waking up,” transmitting this signal via
short-range radio (BLE), and then returning to a low-power state.
The beacon has no user interface (UI) or cellular or GPS capabilities. The
beacon’s identity is encoded within the signal it transmits.
SPECIFICATIONS
Bluetooth low-energy
Ad rate: 100ms (iBeacon certified)
Range: 60 meters / 200 feet
Battery life: Up to 5 years
Operating temp: -40 to +85 degrees Celsius
Indoor/outdoor: NEMA 3R enclosure
Security: Patent pending Verve Beacon Security
Made in USA
Step 1:
Clean the surface
where you will affix
the beacon.
Step 2:
Remove protective
paper from beacon
and adhere beacon.
HOW TO INSTALL YOUR VERVE BEACON
IMPORTANT SAFETY INSTRUCTIONS
FOR YOUR BEACON
• WARNING — CHOKING HAZARD: Small parts. Not for children
under 3 years of age.
• CAUTION: This product comes with a lithium ion battery. Do not
connect improperly, charge, or dispose of in fire. Battery may explode
or leak.
If the battery leaks:
- Do not allow the leaking fluid to come in contact with skin or
clothing. If contact has already occurred, flush the affected area
immediately with clean water and seek medical advice
- Do not allow the leaking fluid to come in contact with eyes. If
contact has already occurred, DO NOT rub; rinse with clean water
immediately and seek medical advice. Take extra precautions to
keep a leaking battery away from fire, as there is danger of ignition
or explosion
- Vapor generated from burning batteries may irritate eyes, skin,
and throat. If inhalation occurs, move to a well-ventilated area
immediately and seek medical advice
• Changes or modifications not expressly approved by the party
responsible for compliance could void the user’s authority to operate
the equipment.
Les changements ou modifications non expressément approuvés par
la partie responsable de la conformité pourraient annuler l’autorité de
l’utilisateur à utiliser cet équipement.
• This device complies with FCC Part 15 and Industry Canada license
exempt RSS standard(s). Operation is subject to the following two
conditions: (1) this device may not cause interference, and (2) this
device must accept any interference, including interference that may
cause undesired operation of the device.
Le présent appareil est conforme aux CNR d’Industrie Canada
applicables aux appareils radio exempts de licence. L’exploitation est
autorisée aux deux conditions suivantes: (1) l’appareil ne doit pas
produire de brouillage, et (2) l’utilisateur de l’appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est
susceptible d’en compromettre le fonctionnement.
The Bluetooth® word mark and logos are registered trademarks owned by the Bluetooth SIG, Inc.
and any use of such marks by Verve Wireless, Inc. is under license.