User Manual
| Download: |  |
| Mirror Download [FCC.gov] | |
| Document ID | 789444 |
| Application ID | 4PBI2JrlmyfzlG/0YtyjoA== |
| Document Description | User Manual |
| Short Term Confidential | No |
| Permanent Confidential | No |
| Supercede | No |
| Document Type | User Manual |
| Display Format | Adobe Acrobat PDF - pdf |
| Filesize | 33.06kB (413288 bits) |
| Date Submitted | 2007-05-07 00:00:00 |
| Date Available | 2007-05-07 00:00:00 |
| Creation Date | 2007-05-03 11:52:18 |
| Document Lastmod | 2007-05-03 11:59:11 |
| Document Title | User Manual |
Dyna Blade”I R/C Mini Helicoper 8+ Easy to Fly! Anyone can master it like a PRO! Age Instruction Manual Tail Rotor x 1 (Spare part) Ballast Label x i f” ) Dyna Blade“ R/C Mini Helicopter xi Controller xi Antenna x 1 Charger Base Station x 1 g“ GETTING STARTED: 1 Assemble antenna to Controller 2 Install batteries in Charger Base Station 3 Install battery in Controller Align the (+) and H polarities correctly with the corresponding markings lX ”9V" 6 X ”C" REQUIRE: a x 1.er cam; batteries (nor INCLUDED) in Charger Base Station. l x w (5mm) battery (nor lNCLUDED] In Controller. Note: For best performanzmlkarine batteries are recommended Inor INCLUDE ). i is CHARGiNG YOUR DYNA BLADEYM RIC MINI HELICOPTER: '| Switch OFF Dyna Blade'M R/C Mini Helicopter Charger‘s Plug Power ON/OFF Charging Socket , When the charger is power"0N”, green LED will light uprThe red LED 2 We”? “We” PM? Will light up when the helicopter is“CHARGlNG".When the red LED |nto helicopter as shown goes off, charging is finished NOTE: (1) Charging takes around 20-30 minutes, (2) Shorter charging time may occur if your Dyna Blade” RIC Mini Helicopter battery is only partially drained. (3) Disconnect your Dyna Blade“ R/C Mini Helicopter from Charger Base Station when charging is completed, (4) Average flight time is around 4 to 6 minutes offone full charge. (SI Charge time and flighttime may vary depending on Charger Base Station battery leveI. (6) When charging time exceeds 30 minutes and flight time fails noticeably short, replace the Charger Base Station batteries with brand new ones. 5 =H PREPARlNGTAKEOFF: 1 Extend Controller antenna fully and turn on Controller Turn on your Dyna Blade“ RC Mini Helicopter and place it on Charger Base Station 3 Place your left thumb over the throttle stick and push up gently Your Dyna Blade“ RC Mini Helicopter will take off now! i ‘ ’\\ TRIM CORRECTION: 1 Hovering 2A Out of Trim: Spinning clockwise 28 Out ofTrim: Spinning anti-clockwise (i) Hover your Dyna BladeM RC Mini Heiimpter about 3 feet above ground (stay at constant altitude), You may need to continuously adjust throttle gently up or down to achieve hovering. (2) HOVER TRlMMlNG ' if your Dyna Blade" RC Mini Helicopter ShQWS one of the followings: A. Spin clockwise f gently slide the trimmer to your right hand side until the hovering helicopter stays straight B. Spin counter-clockwise ‘ gentiy slide the trimmer to your left hand side until the hovering helicopter stays straight. Ct Stay straight - no trimming required, ‘ (3) When trimming is done, your Dyna Blade“ RC Mini Helicopter is now all Set and ready to fly at your command! Z is STARTINGTO FLY: A NOTE: BUILT-lN ELECTRONIC PROTECTION | r.--' ~ »-~ .. , . 9 -» . .. r. — i Sir-“fl FLYING TIPS: . Always press and pull gently the throttle and direction sticks during flight control.The proportional controls respond precisely to small movement of control slick. ~ Beware of turbulence and strong winds in the flying area. Your Dyna Blade“ RC Mini Helicopter may wobble, or be blown off its track, or even dive back to ground as a result. — Never fly your Dyna Blade“ RC Mini Helicopter over 10 feet above ground or get too close to the ceiling. - If your Dyna Blade" RC Mini Helicopter is about to hit onto an obstacle, crash, or losing control, release the throttle stick immediately and let the helicopter fall freely and safely back to ground, Stick the ballast label as shown FLVlNG FASTER FORWARD A When you have got sklllful with the control, try sticking the ballast label (includedl underneath the nose ofthe canopy. (see picture) This will increase the forward speed of your Dyna Blade" RC Mini Helicopter significantly Now enjoying ma maximum fun offlying Dyna Blade“ RC Mini Helicopter! ‘ - Get both frequencies(27.145MHz and 27.195MH2) of Dyna Blade‘“ RC Mini Helicopter to fly together, to race or even doing formation flight with your friends! fin IMPORTANT SAFETY INFORMATION: ~ Keep Dyna Blade” RC Mini Helicopter clear from face and eyes at all times. - Keep fingers away from spinning rotors. - Always flyin wide open space without any obstacles. - Do not fly towards people or animals. - Do not fly under adverse weather condition. - Always fly In warm and sunny days, with liltle or no wind r Do not fly in temperatures below 45°F/7’C. . Adult supervision recommended, 2 E (X BATTERY SAFETY INFORMATION. Batteries should always be replaced by an adult. , Do not mix old and new batteries , Do not mix alkaline, slanderdlCarbonAZinc),0r rechargeablelNickelcadmium or Nickel Metal Hydride) batteries. - Non-rechargeable batteries are not to be recharged, . Rechargeable batteries are to be removed from the toy before being chargedili removable). - Rechargeable batteries are only to be charged under adultsupewisloniif removable). - Different types of batteries or new and used batteries are not to be mixed. « Only batteries ofthe same or equivalent typeas recommended are to be used. - Batueries are to be inserted with the correct polarity. » Exhausted batteries are to be removed from the toy. , l‘ne supply terminals are not to be short—circuiied. - Do not dispose of battery infire, Battery mayexpiode or leak as a resulL » Remove batteries irom the toy before prolonged storage. . » Disposed of used batteries properly Please retain this information For future reierence ; E filACAUTlON: Dyna Blade“ RC Mini Helicopter is powered by a lightweight Lithium Polymer rechargeable battery and extra care musrbe taken during use, Failure to fallow these care and handling instructions can quickly result In severe, permanent damagetc the Lithium Polymer rechargeable battery and its surroundings. - Charge the Dyna Blade“ RC Mini Helicopter ONLY with the provided ChargerBase Station NEVER attempt to charge with any other charger. » The newly purchased Dyna Blade“ RC Mini Helicopter is only partially charged. Full charge the Dyna Blade" Helicopter beiore first use. - Always lull charge the Dyna Blade“ RC Mini Helicopter in repeat use. - Do not recharge the Dyna HIade“RC Mini Helicopter immediately afier use.Walt until it is cool before recharging, - Do not charge nearfire, or where temperature is extremely high, nrwhere It iswet or damp. - During charging, keep Charger Base Station and Dyna Blade“M RC Mini Helicopter away from combustible materials including paper. plastic, carpets, vinyl, ieaiher, wood and never charge insidea full—sized automobile! — Never attempt to disassemble ormodlfythe Dyna Blade“ RC Mini Helicopter as it may damage the Lithium Polymer rechargeable battery insider - Always store the Dyna Bladem RC Mini Helicopter ln cool and dry place Keepawayrrurnr direct sunlight. - Do not allow (he Dyna Blade“ RC Mini Helicopterto get wet , in cold or high altitude environments, the Dyna Blade" RC Mini Helicopter may not perform as good. ‘ . - Always switch orithe Dyna Blade“N RC Mini Helicopter after useor before storagel . If the Dyna Blade” RC Mini Helicopter cannot lifi offunderfull rhroule, Mharge it immedialely. , Never leave the Dyna Blade" RC Mini Helicopter and Charger Base Station unattended at any fimeduring charging. - Always full charge the Dyna Blade” RC Mini Helicopber before prolonged smrage. Examination and recharging should be carried out periodically. ~ if the Dyna Blade“ ac Mini Helicopter shows severe damages or deformation under improper use and handling, stop using immediately and disposed of properly. 2 i“ FCC/EMC REQUlREMENTS: This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Note :Thls equipment has been rested and found to comply with the limits fora Class 8 digital device. pursuant to Part 15 of the FCC Rules These Ilmlrs are designed to provide reasonable protection against harmful interference in a residential insiallatlonJhis equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions may cause harmful interference to radio communications However there is no guarantee that interference will not ocizur in a parricuiar installation if this equipment does cause harmful interference to radio or television reception, which can be determined bywrnlng the equipment off and on, the user is encouraged to try m correct the interference byone or more of the following measures: ~ Reorlentor relocate the reteiVing antenna. » Increase the separation between the equipment and receiver. - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. — Consult the dealer or an experienced radio/TV technician for help. Warning: Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user’s authonryto operate the equipment. Mmulhclui‘ed round rilrurbured by ©1006 Dekko'lbys Cmparly ltd. rill rightsrmrved. roductand colors may vary. “WANNA, New Mandflfln Plan, arefvlrymd the pruned instruction manual as lr cousins lrnaerunr infurmzrion. . 14 Selena. Museum nmramsnaeal cast. Conform to praavrraareiy standard Asm FBGWS and am regulatory requiremenrs lambda, Hung Kong lease retain liar tnisnnauon for runne referenre. tel: (mi 3520 mo Fart: (as!) 3107 oars M’anr'teni «zoom. IiemfiZDWiiZZHSM-i‘fllmfimmi (27.195Ml’ii) Email: inkedekhmwysimm MADflN (NlNA. Oyna made lstndmrkofoekknroysCompany Lid.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : No XMP Toolkit : 3.1-701 Create Date : 2007:05:03 11:52:18Z Modify Date : 2007:05:03 11:59:11+08:00 Metadata Date : 2007:05:03 11:59:11+08:00 Format : application/pdf Document ID : uuid:6d76d911-b310-428a-891b-0de73d33c63c Instance ID : uuid:fe751dab-47a2-4101-b0df-455f78177fd1 Page Count : 4EXIF Metadata provided by EXIF.tools