Viper Design VPR9XYLN Sub GHz Communication Module User Manual FCC Part 15

Viper Design, LLC Sub GHz Communication Module FCC Part 15

Manual

3998 FAU Blvd. Suite 310 Boca Raton, FL 33431 Tel: 561-961-5585 Fax: 561-961-5587
Certification Exhibit
FCC ID: 2AB7YVPR9XYLN
IC: 20699-VPR9XYLN
FCC Rule Part: 15.247
ISED Canada Radio Standards Specification: RSS-247
ACS Project: 16-2053
Manufacturer: Viper Design, LLC
Model: VPR9XYLND
User Manual
Features
• 915Mhz - 928M
hz Wireless Link
•
UART/SPI interfaces
•
Support for both mains
battery-powered
devices
•
Operating Voltage: 2.6VDC
typical
•
Temperature Range:
Integrated Networking
Stack
•
Integrated power management
•
Integrated wireless Link
VPR9XYLN
D
Users Guide
VPR9XYLN
hz Wireless Link
:
UART/SPI interfaces
Support for both mains
-powered and
devices
Operating Voltage: 2.6VDC
to 3.6VDC
Temperature Range:
-40C to +85C
Stack
Integrated power management
Integrated wireless Link
Applications
•
Battery Chargers
•
Power Supplies
•
Smoke Detectors
•
Low Power Wireless
Networks
Users Guide
VPR9XYLN
D
Applications
Battery Chargers
Power Supplies
Smoke Detectors
Low Power Wireless
Networks
VPR9XYLND
Viper Design LLC
125 Glancy St
Goodlettsville, TN 37072
Phone: 615-325-0966
Version 0.
2
Page
2
of
5
Note
Warning: Changes or modifications to this device not expressly approved by Viper Design LLC could
void the user’s authority to operate the equipment.
FCC Two-Part Warning Statement:
VPR9XYLND
Viper Design LLC
125 Glancy St
Goodlettsville, TN 37072
Phone: 615-325-0966
Version 0.
2
Page
3
of
5
Class B Device
“NOTE: This equipment has been tested and found to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates, uses,
and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.”
RF Exposure
This equipment complies with radiation exposure limits set forth for an uncontrolled environment.
This equipment should be installed and operated with Maximum distance 20 cm between the radiator
and your body. This transmitter must not be co-located or operating in conjunction with any other
antenna or transmitter.
Cet équipement est conforme aux limites d'exposition aux radiations dans un environnement non
contrôlé. Cet équipement doit être installé et utilisé à distance minimum de 20 cm entre le radiateur
et votre corps. Cet émetteur ne doit pas être co-localisées ou opérant en conjonction avec tout autre
antenne ou transmetteur.”
Low Power License-Exempt Device
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions: (1) this device may not cause interference, and (2) this device must accept
any interference, including interference that may cause undesired operation of the device.
VPR9XYLND
Viper Design LLC
125 Glancy St
Goodlettsville, TN 37072
Phone: 615-325-0966
Version 0.
2
Page
4
of
5
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts
de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) l'appareil ne doit pas
produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique
subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
Labels
Host Device must contain the following label on the outside of the unit:
Contains FCC ID: 2AB7YVPR9XYLN
Contains IC
:
20699
-
VPR9XYLN
VPR9XYLND
Viper Design LLC
125 Glancy St
Goodlettsville, TN 37072
Phone: 615-325-0966
Version 0.
2
Page
5
of
5
Operational
Supply Voltage: 2.6VDC to 3.6VDC
Operating Temperature: -40C to +85C
Radio
915Mhz:
Communication Interface:
UART (2 wire: TX, RX)
Line interface options: Logic level, RS-232, or RS-485
Data Format: 8 data bits, 1 stop bit, configurable parity bits
Baud Rate: Configurable up to 115.2k
SPI (4 wire logic level: SS, SCLK, MISO, MOSI)
Data Format: 8 data bits
Data Rate:
SPECIFICATIONS

Navigation menu