Vision Automobile Electronics Co JO-174 Outdoor Door Sensor User Manual JO 174 Manual
Vision Automobile Electronics Industrial Co Ltd Outdoor Door Sensor JO 174 Manual
Users Manual
JO-174 Door / Window Sensor
Item No. :
Cet appareil numérique de la classe [B] est conforme à la norme NMB-003 du
Canada.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux
appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions
suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de
l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
est susceptible d'en compromettre le fonctionnement.
Commission Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses, and can radiate radio frequency
energy and, if not installed and used in accordance with the instruction, may cause harmful interference
to radio communications. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which can
be determined by turning the equipment off and on, the user is encouraged to try and correct the
interferene by one of the following measures:
- Reorient or relocate the receiving antenna,
- Increase the separation between the equipment and receiver,
- Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and (2) this device must accept any interference
received, including interference that may cause undersired operation.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate this equipment.
Door / Window Sensor
JO-174 is a supervised, wireless, door/window contact intender for use with Alarm
systems. Place door sensor & magnet separately on door/window and door /window
frame. As signal will be sent if door/window is open which will be detected by JO-174.
User will alerted if the door/window is open.
Features
* Tamper Switch
* Battery Detection
* LED Status Indicator
* Magnetic Seperation Trigger Function
* Battery Life: 5 Years
CommunicationProtocol345MHz
FrequencyUS
CurrentStaticcurrent:<4uA
VoltageDC3V
OperatingRange.Over30M
OperatingTemp.MIN:‐40℃,MAX:+66℃
Battery2x3號(AA)Battery
Installation Double Sided Foam Tape