Vision Automotive Technology 819108 TPMS REPEATER User Manual

Download:
Mirror Download [FCC.gov]
Document ID	4121405
Application ID	54R7QkT+ppKOWLIk02OkiQ==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	70.67kB (883339 bits)
Date Submitted	2018-12-28 00:00:00
Date Available	2018-12-28 00:00:00
Creation Date	2018-11-02 15:31:43
Producing Software	Microsoft: Print To PDF
Document Lastmod	2018-11-02 15:31:43
Document Title	Microsoft Word - Owners Manual 819108 TPMS REPEATER SYSTEM
Document Author:	Vision

TPMS REPEATER SYSTEM - 819108
FITTING REPEATER
Repeater should be mounted to the A Frame of the trailer as close to the vehicle tow ball as possible using the hardware provided
POWERING THE REPEATER
BATTERIES
1)
2)
3)
4)
Remove battery cover by removing the 5 screws on the top
Insert the AA batteries provided and re-fit the battery cover
Ensure the seal is seated correctly and not twisted when re-fitting screws.
Do not over tighten screws. (screws should be hand tightened only)
12V+ UPGRADE KIT - 819109
1)
2)
Remove battery cover by removing the 5 screws on the top
Plug 2 pin connector from upgrade kit into repeater as shown below
3)
4)
Refit 12V upgrade kit in place of battery cover
Using the 3 longer screws provided, screw upgrade kit into position as shown and use 2 of the previously removed screws in
the remaining 2 holes
5)
6)
7)
Ensure the rubber seal is seated correctly and not twisted when re-fitting screws.
Do not over tighten screws
Wire up repeater to constant 12V power source with 5 AMP inline fuse (not included)

RED – 12V+

BLACK - EARTH
PROGRAMMING TRAILER
Sensors must first be learnt to Repeater
Its recommended to use 2 people for the next step or pair module before mounting
1)
2)
3)
4)
5)
Knock or shake the unit to “wake” repeater
Using a pen or small blunt object, press and hold the “program” button on the repeater until the RED LED becomes solid
Activate any sensor by either using the LF tool for internal sensors or screwing in the external sensor into the tyre. RED LED will
flash when tyre ID is learnt.
Repeat for remaining sensors. If trailer has 4 wheels, repeat same procedure for all tyres.
Once all tyres are learnt, press and hold the “program” button until the RED LED turns off
RED LED
Program Button
Programming Display
1)
2)
3)
4)
5)
6)
Press SET button 6 times, unit will beep once and enter Trailer program mode
Knock or shake the unit to “wake” repeater
Front left tyre will be flashing, activate corresponding sensor by either using LF tool for internal sensors or unscrewing and then
re-screwing on external sensor. Unit will beep once when tyre ID is learnt
Press SET 1 time to save ID and change to next sensor
Repeat steps 3 and 4 for remaining tyres
Press and hold the SET button for 5 seconds after all tyre ID has been learnt to save and exit trailer mode

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.7
Linearized                      : No
Warning                         : Info object (48 0 obj) not found at 882058

EXIF Metadata provided by EXIF.tools