Visiplex VNS22XX Wireless Paging Controller User Manual WPRP 1 Manual

Download:
Mirror Download [FCC.gov]
Document ID	3090126
Application ID	tOMMP/v2Qq6L4EKqye6nlw==
Document Description	WPRP-1 Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	33.2kB (414999 bits)
Date Submitted	2016-08-05 00:00:00
Date Available	2016-08-05 00:00:00
Creation Date	2016-07-29 13:03:12
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2016-07-29 13:03:12
Document Title	WPRP-1 Manual

WPRP-1 Installation Guide
WPRP-1 Installation
1.
Determine the installation location for the WPRP-1 device. Consider the following when determining the installation location:
 Standard WPRP-1 device is equipped with AC to DC power adaptor and require a standard 110VAC or 220VAC power outlet.
The power adaptor consists of 6’ DC power cable and 6’ of AC power cord. Consider these cable lengths and the distance
between the power outlet and the WPRP-1 device.
2.
Position the WPRP-1 device on the mounting surface and confirm that it is vertical to the floor.
Note: When the device is installed properly, the LED should be on the left top corner (front view).
3.
Secure the WPRP-1 device to the wall using screws appropriate for the mounting surface (use 1.5”-2” long screws).
4.
Connect the external antenna (2.5db or 3db gain) to the BNC connector.
5.
Connect the output devices to their respective port. Below are the available connector types that may be installed on your
device:
6.
Connect the power adaptor male connector to the POWER port of the WPRP-1 device.
Note: The WPRP-1 devices should be protected from direct rain and snow, and if possible, from direct sun. These devices are
suitable for outdoor installation. Yet, the devices are not watertight and it’s highly recommended that outdoor installation locations
will include an overhang to protect the WPRP-1 device from direct rain, snow and sun.
WPRP-1 – Connections
Transmit Antenna
Status LED
POWER (6 Pin Female)
Port Pin Out (Front View)
POWER /
Programming
1 – VDC (IN)
2 – GND
3 – GND (Battery)
4 – RX (RS232)
5 – TX (RS232)
6 – N.C.
WPRP-1 Installation Guide – Version 2.00
Notice to User Regarding Radio Frequency Interference
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not
cause harmful interference, and (2) this device must accept any interference received, including interference that may cause
undesired operation.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to
operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more of the
following measures:
‐Reorient or relocate the receiving antenna.
‐Increase the separation between the equipment and the receiver.
‐Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
‐Consult the dealer or an experienced radio/TV technician for help.
RF Radiation Hazard Warning: To ensure compliance with FCC RF exposure requirements, this product should be positioned no
less than 30 cm from your body or nearby persons during continuous use.
WPRP-1 Installation Guide – Version 2.00

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : 
Create Date                     : 2016:07:29 13:03:12-05:00
Modify Date                     : 2016:07:29 13:03:12-05:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Format                          : application/pdf
Creator                         : 
Title                           : 
Document ID                     : uuid:1b495f60-ec39-4e70-ad87-2ce6fb568365
Instance ID                     : uuid:3c8ecc9a-5f03-4951-a622-f3876be69929
Page Count                      : 2

EXIF Metadata provided by EXIF.tools