Visonic MP840 PIR detector User Manual D 306082 MP 840 PIR ZB EN 00x

Visonic Ltd. PIR detector D 306082 MP 840 PIR ZB EN 00x

Users Manual

D-306082 MP-840 PIR ZB 1 MP-840 ZigBee Home Automation 1.2 Wireless Digital Pet Immune PIR Detector Installation Instructions 1. INTRODUCTION The MP-840 (pet immune) is a microprocessor-controlled wireless digital PIR detector supported by H.A 1.2 panels using ZigBee Home Automation. The detector’s features are as follows: • Fresnel and cylindrical lenses with uniform detection sensitivity throughout its operating range, up to 12 meters (39 ft). • Target Specific Imaging™ (TSI) technology is used for distinction between humans and pets weighing up to 38 kg (85lb). • The advanced True Motion Recognition™ algorithm (patented) allows distinguishing between the true motion of an intruder and any other disturbances which may cause false alarms. • No vertical adjustment is needed. • An on-board motion event jumper determines whether 1 or 2 consecutive motion events trigger an alarm. • After detection, the detector disarms itself to save battery power. It rearms (reverts to the ready state) if there is no subsequent detection throughout the following 2-minute period. • Very low current consumption. • Microprocessor-controlled temperature compensation. • White light protection. • Front and back tamper protection. • Elegantly styled, sturdy case. • The device support on temperature’s report according to HA1.2’s panel. For UL installations: The detector is for use with UL listed control unit only. Pet immunity has not been evaluated by UL. Figure 1: MP-840 2. SPECIFICATIONS Detector Type Dual element low-noise pyroelectric sensor OPTICAL Lens Data Max. Coverage Pet Immunity (pet version) 27 Fresnel “far” lenses (54 sensitivity “beams”) 18 cylinder “mid” curtain lenses (36 sensitivity “curtains”) 10 cylinder “close” curtain lenses (20 sensitivity “creep curtains”) 12 x 12 m, (39 x 39 ft) / 90° Up to 38 kg (85 lb) ELECTRICAL Internal Battery 3V Lithium battery, type CR-123A. For UL installations, use Panasonic and GP only Nominal Battery Capacity 1450 mAh Battery Life (with LED on) Battery Power Test FUNCTIONAL Typically over 5 years Note: Inability to connect with wireless network, or wireless link quality no higher than 20% may significantly reduce the expected battery life. Performed immediately upon battery insertion and periodically after every several hours True Motion Event Verification 2 position selector - 1 (OFF) or 2 (ON) motion events Alarm Period 2 seconds LED Switch LED Enable (red LED lights for 2 sec. upon Alarm detection) LED Disable: No indication. (LED is always enabled during Walk-Test mode) Rearm Timer Rearms the detector 2 minutes after the last alarm. Timer disabled in the walk test mode

Navigation menu