WALTOP SBPKL10 Maker Pen User Manual SBP KL10

UserMan

SBP-KL10 Pen Quick Start Guide

Specification

‧ Battery: CR-2032 Battery

‧ Battery life: Continuing writing 1.5 months

‧ Power saving function:

Get into auto sleeping mode while pen is covered.

How to change battery

1. 2. 3.

電子白板筆 Maker Pen

太瀚科技股份有限公司

Placing the CD driver

Place the installation CD in your CD driver

Click on the tablet icon at the bottom right oh the tool bar

(The tablet icon appears when the cable is plugged in.)

You enter the Tablet screen.

To select function, click on buttons on

the tool bar.

Federal Communication Commission Interference Statement

This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio or

television reception, which can be determined by turning the equipment off and on, the user is encouraged

to try to correct the interference by one of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)

This device may not cause harmful interference, and (2) this device must accept any interference received,

including interference that may cause undesired operation.

FCC Caution: Any changes or modifications not expressly approved by the party responsible for

compliance could void the user's authority to operate this equipment.