Wacom Co CT0405U Digitizing Tablet w/Serial Port User Manual 54902
Wacom Co Ltd Digitizing Tablet w/Serial Port 54902
Wacom Co >
8
I MT "00 woavm Wm [mum/q S‘JSSQ 191m HSH fl—8090/90170-l0 User’s Manual: CT-0405/0608-U USB Tablet May 15, 1998 - Version 0.1 WACOM Technology Corporation 1311 SE Cardinal Court,Vancouver, WA 98683, U.S.A. Telephone 1—360—89679833(General) FAX 17360-896-9724 WACOM Computer Systems GmbH: Hellersbergstrasse 4, D-41460 Neuss, Germany Telephone 49—2131712390(General) FAX 494131401760 WACOM Co., Ltd. 2-510-1 Toyonodai, Otonefmachi, Kitasaitama-gun, Saitama, 349-1148, Japan Telephone 81-480—78-1213(Genera1) FAX 81-480-78—1217 VIACOM Korea Co., Ltd. 371—36, Kasang-dong, Kumchorrku, Seoul, 153-023, Korea Telephone 82-27869—5595(General) FAX 82-2—869-1241 © 1998 VIACOM Co., Ltd. All righis rMSk‘. No part of this manual lay be reproduced in any l‘ur- or by any liens without (he pri itlen consent of NAHUM Cm, Lid. VIACOM Co., Lid. rnservns the, right to revise lhis Publltdtlfln without obligalion to provide notifiodiiun ol‘ such changes. in no evenl will WACOK he liahle [or direct, indirect, special, incidental, or (iunsoqllenlinl dalages resulting fro: any dul‘eoi in the sni‘lware, Line hardware, or ilUUlIlimlfil—iflh. FCC Notice The equipment described in this manual generates, uses, and can radiate radio— frequency energy. If it is not installed and used properly (that is, in strict accordance with Wacom instructions) it may cause interference with radio and television reception. Federal Communications Commission (FCC) Notice This equipment has been tested and found to comply with the limits for a Class B digital device in accordance with the specifications in Part 15 of FCC rules. These specifications are designed to provide reasonable protection against such interference in a residential installation. However, there is no guarantee that interference will not occur in a particular installation. You can determine whether your tablet is causing interference by discon- necting it from the computer. If the interference stops, it was probably caused by the tablet. If your tablet does cause interference to radio or television reception, try to correct the interference by using one or more of the following measures: E llotate the television or radio antenna until the interference stops. Move the tablet to either side of the television or radio. Move the tablet farther away from the television or radio. Plug the computer (and serial tablets) into an outlet that is on a differ? ent circuit from the television or radio. (That is, make certain the com— puter equipment, and the television or radio are on circuits controlled by different circuit breakers or fuses.) If necessary, consult your authorized Wacom dealer or an experienced radio/television technician for additional suggestions. You may find helpful the following booklet, prepared by the Federal Communications Commission: Interference Handbook (stock number 0047000-00345—4). This booklet is avails able from the 11.5. Government Printing Office, Washington, DC 20402. Changes or modifications to this product not authorized by Wacom Technolf ogy Corporation could void the FCC Certification and negate your authority to operate the product. This product was tested for FCC compliance under conditions that included the use of shielded cables and connectors between system components. It is important that you use shielded cables and connectors to reduce the possibiif ity of causing interference to radios, television sets, and other electronic devices. Proper Usage To ensure the proper usage of your graphics tablet, avoid using or storing the tablet in places where: [1 DD El Infants can reach . Temperatures may exceed the operating temperature range of 4qu to 104°]? (or 5.C to 40.0). A severe temperature change may occur, such as outdoors or in a vehicle. There is high humidity (operating humidity: 20% to 8075). There is a lot of dust or moisture. There is exposure to direct sunlight or close to a heating de— vice such as a heater. There is exposure to strong magnetic fields. Cautions in Handling DDD Avoid intensive shock or vibration. Do not hit or drop the graphics tablet or components. Do not disassemble the tablet or stylus. Do not use thinner, benzene, alcohol or other volatile liquids on the tablet or stylus. Use diluted neutral detergent with a soft clean cloth, tightly squeezed out. CT ENDS 0508 U USE Tablcflt Contents 1. The Wacom Advantage ............... 6 2. Getting Started ................... 7 3. Installing the Tablet ............. 12 4. Maintaining the Tablet ............ 14 5. Specifications .................... 16 U USE Tabb: v'dlnlrn 1. The Wacom Advantage Congratulations for choosing the “Wacom advantage" and welcome to the world of cordless digitizing! Wacom technology provides a set of drawing tools that are ergonomically designed to be natural extensions of the hand. Cordless and light weight, these drawing tools make drawing or writing on a Wacom graphics tablet feel as comfortable as using a pen on paper. The Wacom CT—O405/0608-U USB Tablet User’s Manual provides a detailed description of each type of CT—0405/0608 tablet and its stylus, in— cluding its installation, use and maintenance. A description of the Wacom software driver that is provided with the tablet is included under separate cover. Contents of the Package The Wacom CT-0405/0608-U USE tablet comes equipped with a stylus (pen) and software in a CD—ROM. llote: Save? the paaaging materials that came with the WaciomirCT- 0405/0608—U tablet. You may need these items to store or ship the tablet in the future. Technical Support Contact your local Wacom distributor for technical support. 2. Getting Started The Wacam CT-U405/0608-U tablet is sometimes called graphics tablet, digitizers or tablets. In each case, the CT—0405/0608—U tablet is an electronic device that transmits coordinate data for graphics and hand writing to the software on the host computer. The CTf0405/0608-U tablet continuously transmits data to and from a pointing device, such as a stylus (pen). When transmitting, the tablet sends a signal to the pointing device. The pointing device stores en- ergy from the signal. When receiving, the pointing device sends a signal that carries coordi- nate, switch, and pressure data back to the tablet. The tablet sends this data to the computer, Figure 2—1. Macon CT—0405/0508—l/ TabJet CTJIMOS OGOBVU USE Ttnl If! Uwv a Mrlenml CT-0405/0608-U USB Graphics Tablet The CT70405/06087U tablet can be connected to a computer that provides an interface for a USB port. The CT-0405/0608—U tablet contains the following components: Figure 2—2, Vacant CT—0405—U USE Tablet Figure 2-2. Wacun ”7060va 11.93 Tablet 8 Thing 1 USB Connector The cable is Connected to the tablet and is ready for installation to a USB port. 2 Status Light When the status light is orange, the tablet is on. When the status light is green, a stylus is on the active area of the tablet with a switch pressed. 3 Active Area A stylus can be used on the active area. Stylus The CT-0405/06087U tablet is equipped with a UP-703E stylus. 1 2 3 Figure 2-3. Stylus Parts Tip Switch The tip switch is pressurefsensitive and is activated when you press it down on the tablet’s surface. The function of the tip switch is defined by the Wacom Tablet driver. Side Switch The side switch is activated when pressed. The function of the side switch is defined by the Wacom Tablet driver Eraser End The eraser end is also pressure—sensitive and is activated when you press it down on the tablet’s surface. The function of the eraser end is a pressure sensitive tool that is defined in particular application software. 10 ISE Ti—ilrlul Uwfl a Mummi Holding a Stylus When you use a stylus, hold the stylus as you would a pencil. Be sure to position your fingers to avoid accidental hitting of the side switch. Figure 2—4 . Holding a Stylus 11 3. Installing the Tablet The CT70405/06087U tablet is connected to a USB port using the USB cable/lo install the CT—0405/0608—U tablet: 1. Turn off your computer. 2. Plug the USB connector into the USB port of your computer. [158 Comect or [3n— . to USB Port Computer Figure 2-6 . Connecting the Tablet to your computer (sale way for CT—OSGS) 5. Turn on your computer. 6. Place your stylus on the active area of the tablet and press down. The status light should turn green. If you encounter problems, refer to the Installation Testing in this chapter. 7. If the installation is OK, install the compatible Wacom Tablet driver using the accompanying software manual. 12 Installation Testing If the CT~0405/0608-U tablet does not work properly after installation, check connection to be sure you have installed the tablet correctly and try the following procedures. If the CT-0405/06087U tablet continues to operate improperly, contact your local distributor. Check if the status light becomes orange If your status light does not show orange, the CT~0405/06087U tablet is registering that it is not receiving power. Check that the USB connector is securely connected to the USB port of your computer. Check if the status light becomes green When the tip or side switch of the UP7703E stylus is pressed while the stylus is on the active area of the tablet, or the eraser of the stylus comes in the active area, the status light should become green. If the status light does not show green when either the tip or side switch is pressed or when the eraser of the stylus comes in the active area, contact your local distributor. 13 OBOE—U USE ti 5 Manual 4. Maintaining the Tablet Regular maintenance of the tablet helps prolong its life. Care Use proper care when working with or storing the tablet and it’s compo- nents. Avoid extreme heat and cold. Do not store components outdoors. Do not allow the components to stay in direct sunlight. Do not allow any fluids to come into contact with the components, except when Cleaning. El Keep the tablet surface free of dust. IlDo not drop or hit the tablet or stylus. jDo not let any volatile liquid, like paint thinner, turpentine, or benzene touch the tablet. These liquids can damage the plastics that are used in the tablet. 14 as u use T Cleaning Grit on the tablet may adhere to a pointing device, causing scratches on your tablet’s surface. To clean the tablet: 1. Unplug the USB cable from your computer. 2. Dilute a neutral detergent solution, such as dish washing liquid, in a, bowl of lukewarm water. 3. Dip a soft cotton lint—free cloth in the detergent solution and wring it out. The cloth should be damp, not wet enough to drip water on the tablet. 4. Use the cloth to clean the tablet surface and stylus as needed. Note: Do not clean the tablet or stylus with any volatile 1151611? like paint thinner, turpentine, or benzene. Such solvents icon damage p 1 ”this; 15 5. Specifications CT—0405—U USB Tablet Specifications Activeareawxw) 96.0x128.0m Physical size (DxWxi-I) 181.0x196.0x7.0mm —fusmm 1000 line / inch in Resolution £7 Accuracy 100 points / second Upper Operating temperatuer / 5~40“C (41~104°F) / hunidity 20~80% nmcondensing Storage mmperature / —10~60°C (14~140°F) / hunidity 20~90% nmcondensing 16 CT—OBOS—U USB Tablet Specifications Activeamawxw) 152.4x203.2m st1calsize(DxWxI-I) m.5x3m.0x22.0m —_ (berating temmtuer/ 5~40°C (41~104°F) / humidity 2041074 namndensing Storage temperature / >10~60°C (l4~140°F) / humidity 20“ nmcmiensing 17 Pin assignments of connector Jinflgmberiiznal, "531116 1 VCC( 5V) 2 —DATA 3 +DATA 4 GND 18
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.3 Linearized : Yes Create Date : 2001:06:04 09:14:05 Producer : Acrobat Distiller 4.0 for Windows Author : jsoscia Title : 54902.pdf Modify Date : 2001:06:04 09:14:12-04:00 Page Count : 18EXIF Metadata provided by EXIF.tools