Wavetec FZCO WT-CDU CDU (Wired and Wireless) User Manual Wireless CDU

Wavetec FZCO CDU (Wired and Wireless) Wireless CDU

User manual

Central Powered CDU User Guide
Version 1.0
PLM # 701-0005-0003
Date 27nd Oct 2009
Wavetec FZCO, 2009
Page 1 of 5
Central
Power
CDU
Oct 03rd
2011
This document explains the how to use the Wavetec CDU GPC
(Grey, Power Central) User Guide
Central Powered CDU User Guide
Version 1.0
PLM # 701-0005-0003
Date 27nd Oct 2009
Wavetec FZCO, 2009
Page 2 of 5
Table of Contents
1. Specifications ........................................................................................................................... 1
2. Configuration ........................................................................................................................... 3
3. ID Change Procedure: .............................................................................................................. 3
Central Powered CDU User Guide
Version 1.0
PLM # 701-0005-0003
Date 27nd Oct 2009
1
1. Specifications
Model
Dimensions
Display Resolution
Display Color
Display Languages
Counter Number -
Display Area
LED Display Area
Display Type
LED dot
LED pitch
2
Luminous Intensity per dot
(@ IFP=40 mA, duty 1/8)
Max Cable length for CDU
connectivity
Connections
Data Communication
Display Addressability
Power
Operating Temperature
Humidity
3
2. Configuration
Total Number of CDU
Connect at Hub
Wire Length (Meters)
CDU
Current
Text Color
Text
7
21
1.038Amp
Orange
8888
9
14
0.870Amp
Orange
8888
10
7
0.738Amp
Orange
8888
16
49
0.338Amp
Red
8888
15
28
0.490Amp
Green
8888
Note: CDU can connect with maximum wire length of 28 meter.
3. ID Change Procedure:
First locate the ID Change Switch as highlight in the above picture & make sure all dip switches
should be at OFF Position.
Now with the help of pointing thing press & hold this Switch for 3-5 seconds until the display
shows the ID of the CDU, after that release this switch.
Now Press this switch again, you will observe the ID’s is incrementing on the display, Keep
pressing the switch till you get close to your desired ID. Now release and press for a brief period
for single increment till your desired ID has reached. Now stop pressing that switch. In 5 seconds
this will be stored as new ID.
After few seconds the CDU will display startup messages and also show your set ID.
Warning：
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference, and (2)
this device must accept any interference received, including interference that may
cause undesired operation. changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate the
equipment.
NOTE: This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception,
which can be determined by turning the equipment off and on, the user is
encouraged to try to correct the interference by one or more of the following
measures:
-- Reorient or relocate the receiving antenna.
-- Increase the separation between the equipment and receiver.
-- Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
-- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu