Westhold TXLI-02 Race Car Transmitter User Manual Westhold Manual TXLI02
Westhold Corporation Race Car Transmitter Westhold Manual TXLI02
Westhold >
user manual
Westhold Corporation
Installation Instructions – Rechargeable Transmitter
RMS TXLI02 Transmitter
Transmitter - Rechargeable Model: WH-RMS-2180-001
Dimensions Approx. 3” x 2" x 1"
(≈7.6 x 5.1 x 2.5cm)
Weight Approx. 4.9oz (125grams)
Temp Range 32-122°F (0-50°C)
Battery Life 7 Days on full charge
Operational Indicator LED
Low Battery Indicator LED
Humidity 90% Relative
FEDERAL COMMUNICATIONS COMMISSION RADIO AND TELEVISION INTERFERENCE
STATEMENT
FCC ID: NKBTXLI-02
IC: 6677A-TXLI02
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) This device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class A digital device,
pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed and used
in accordance with the instruction manual, may cause harmful interference to radio
communications. Operation of this equipment in a residential area is likely to cause harmful
interference in which case the user will be required to correct the interference at his own expense
Changes or modifications not expressly approved by Westhold Corporation could void the user's
authority to operate the equipment.
Transmitter Mounting
• Label side of the transmitter faces down toward the track.
Note: There are other systems that use a different orientation such as the one on the right. Be careful
about mixing the orientations.
• No metal or carbon fiber between transmitter and track. The transmitter must have a
clear shot to the ground.
Note: Signals can go through plastic so it is possible to use a piece of plastic as a mounting plate.
It is possible to recess the transmitter, however keep in mind that recessing the
transmitter can create problems such as shown below.
1) The label side should face down toward the track.
2) No metal should be between the label and the track.
This is a poor orientation and
will result in inconsistent
performance.
Poor location
: Narrow window for
detection. The signal can’t be seen well.
Good location
: No metal to block the signal.
The detection window is very wide.