Widex A S TM2 TM#2 Programming Unit User Manual Manual

QUICK GUIDE

* If your nEARcom was supplied by another manufacturer, you must insert a Widex Tech Module.

See the nEARcom User Manual.

GETTING STARTED WITH

WIRELESS FITTING

Over the years, hearing aid manufacturers have introduced

more cables to the clinic with the launch of new hearing aids.

For dispensers, this has become a hassle. It can be a real

the connectors engage.

For further details, see the nEARcom User Manual.*

USING nEARcom

DETECT THE HEARING AIDS

1. Insert fresh batteries in the hearing aids and turn on the hearing aids. Identify left

and right by means of the colour marking.

2. Lay the nEARcom on the table and place the hearing aids in the middle of the

neck loop.

• Place BTE hearing aids directly on the table.

• Insert ITE/CIC in the holes in the instrument fixture included with the

Compass – left and right.

Detect hearing aids as follows:

1. To identify hearing aids, make sure they are placed in the middle of the

nEARcom neck loop and then use the Play buttons under Identify HA. When you

select a Play button, the relevant hearing aid plays a sound for 6 seconds and in

some models a light-emitting diode lights1.

2. While this is happening, remove the hearing aid from nEARcom and listen to it.

3. In Compass, select whether the hearing aid is for the left or right ear.

4. Repeat the procedure if you are fitting two hearing aids.

5. Click Next to connect the hearing aids.

WITH THE CLIENT

Let the client wear the hearing aids and the nEARcom. In the fitting screen, click

Detect wireless for wireless fitting.

WHICH HEARING AIDS CAN BE PROGRAMMED

WIRELESSLY WITH nEARcom?

All CLEAR440 and newer hearing aids with wireless technology from Widex are fit-

ted wirelessly. Use Compass V5.0 or a later version.

nEARcom also supports fitting with cables for models where cable fitting is an op-

tion. Connect the usual cables to the pass-through connectors on the nEARcom.

Click the Detect wired icon to fit with cables.

N26346

FEDERAL COMMUNICATIONS COMMISSION AND INDUSTRY CANADA

STATEMENT

FCC ID: TTY-TM2

IC: 5676B-TM2

This device complies with part 15 of the FCC Rules and with RSS-210 of Industry

Canada. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept

any interference received, including interference that may cause undesired opera-

tion.

tion. This equipment generates, uses and can radiate radio frequency energy and,

if not installed and used in accordance with the instructions, may cause harmful

interference to radio communications. However, there is no guarantee that interfer-

ence will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the

equipment o and on, the user is encouraged to try to correct the interference by

one or more of the following measures:

— Reorient or relocate the receiving antenna.

— Increase the separation between the equipment and receiver.

— Connect the equipment into an outlet on a circuit dierent from that to which

This equipment complies with the Industry Canada RF radiation exposure limits set

forth for an uncontrolled environment as per IC RSS-102 Issue 3.

Changes or modifications to the equipment not expressly approved by Widex could

void the user’s authority to operate the equipment.

WWW.WIDEX.COM