Willis Electric AL69-TX Garden Laser Projector User Manual

Willis Electric Co., Ltd. Garden Laser Projector

Contents

User Manual

1. Connect the power adapter and the laser light, the adapter input voltage is AC120V. Attention to avoid laser light to illuminate the eyes, toprevent the glare of the eyes directly.2. Take the laser light in a dark environment, or cover the photoresistor to keep out the light. The effects are different every time when power on.3. Press the button to switch the effects, long press the button to close the laser light, short press the button again to turn on it. During the day,if you press the button, it lights for 10 minutes and turn off automatically after 10 minutes.4. Use the remote control, See the picture below:AL69-TX_A1_User Manual
FCC NOTE: This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. THE  MANUFACTURER  IS  NOT  RESPONSIBLE  FOR  ANY  RADIO  OR TV INTERFERENCE CAUSED BY UNAUTHORIZED MODIFICATIONS OR  CHANGE  TO  THIS  EQUIPMENT.  SUCH  MODIFICATIONS  OR CHANGE  COULD  VOID  THE  USER’S  AUTHORITY  TO  OPERATE  THE EQUIPMENT. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:   -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  -- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu