Users Manual
User Manual
1.1 Battery Installation
.Open the battery cover of mouse.
.Put battery in according to the polarity of the battery, then close the cover.
2.2 Device connection
⑴. Open the bluetooth device of computer.
⑵. Turn on the power supply switch ,holding the CONNECT key for 2 seconds, then the mouse will be in
matching state.
(3). select "Add"in the Bluetooth message box,Refer to below screenshot indicated .
(4). Mark a "√" in the windown message box ,then click"next"to search.
(5). Bluetooth mouse is on the screen ,select "Device"and then click "next"to match.
(6). Select "Non-password"while in matching state after then function is activated .The code will not be replaced
while computer is power off or while batteries are installed.
3.3. Sleeping mode
Press any button to wake-up from Sleeping mode
4.4 Matters needing attention:
⑴.Applications of the mouse will be affected on the rough or reflection surface.
⑵.Don’t disassemble mouse
⑶.Use dry and soft cotton product clean mouse.
⑷.Careful choice battery. its quality affects operation time and mouse life.
Instructions on “wireless”
Transmission frequency is 2.4GHz,it meet R&TTE Directive 1999/5/EC noun in Europe and
its radiation does not harm human body .(far less than the mobile phone’s radiation)
Instructions on battery
Don’t throw the waste battery into recycle bin while replace battery.
§ 15.19 Labelling requirements.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
§ 15.21 Information to user.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the
user's authority to operate the equipment.
§ 15.105 Information to the user.
Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant
to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates uses and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to radio
communications. However, there is no guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the
following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
* RF warning for Portable device:
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable
exposure condition without restriction.