Winspeed A40 2.4GHz Wireless keyboard User Manual XH WM1318

Winspeed Co., Ltd 2.4GHz Wireless keyboard XH WM1318

User Manual

.Applications of the will be affected on the rough or reflection surface. .Careful choice battery. its quality affects operation time and life. .Use dry and soft cotton product clean t disassemble and receiver For convenient to carry, can put Nano receiver into the collection tank of and re-install battery, then replu Nano receiver; , that enter the working state. . Computer will recognize a USB keyboard device.(can be seen from the devicemanager) .Open the battery cover on bottom of keyboard, and pull out the Nano receiver. User Manual 1.1 Battery Installation ⑴⑵.Put battery in according to the polarity of the battery, then close the cover. 2.2 Device connection: ⑴. Put Nano receiver into the computer's USB port, and ensure good contact。 ⑵⑶⑷, you can enjoy wireless freedom. ⑸. If the connection failed，connection methods as follows： can be work normally. 3.3. Sleeping mode: Press any button to wake-up from Sleeping mode 4.4. receiver collection function: For convenient to carry, can put Nano receiver into the collection tank of . 5.5 Environment condition: ⑴.Operation temperature:0 ℃～50℃，humidity:20％RH～90％RH without condensations. 6.6 Matters needing attention: ⑴ ⑵.Don’ ⑶ ⑷Instructions on “wireless” Transmission frequency is 2.4GHz,it meet R&TTE Directive 1999/5/EC noun in Europe and its radiation does not harm human body .(far less than the mobile phone’s radiation) Instructions on battery Don’t throw the waste battery into recycle bin while replace battery. The keyboard of the red light flashing, first and then go out Press the keyboard buttons keyboard keyboardkeyboardkeyboardkeyboardkeyboard
§ 15.19 Labelling requirements. This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. § 15.21 Information to user. Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment. § 15.105 Information to the user. Note: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -Reorient or relocate the receiving antenna. -Increase the separation between the equipment and receiver. -Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -Consult the dealer or an experienced radio/TV technician for help. * RF warning for Portable device: The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure condition without restriction.

Navigation menu