Wintop Electronics WM-783 WIRELESS MOUSE User Manual 1

User manual

Acer Wireless Opcal Mouse

Use Manual

WM-783

Set up the Mouse and connect to a laptop or PC

1. Open the baery compartment cover at the boom of the mouse;

remove USB receiver.

2. Insert two AAA baeries into the baery compartment.

3. Replace the baery compartment cover.

4. Plug the USB receiver into one of your computer’s USB ports.

Now you are ready to use the mouse.

Remarks:

Long press the power switch buon 2 seconds to turn oﬀ the mouse;

Press the power switch buon 1 second to turn on the mouse.

1.5VAAA

USB

power switch buon

US B Receiver

Baery Compartment cover

FCC STATEMENT :

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and

(2) This device must accept any interference received, i ncluding interference that may cause undesired

operation. Warning: Changes or modiﬁcations not expressly approved by the party responsible for compliance

could void the user's authority to operate the equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant

to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful

interference in a residential installation. This equipment generates uses

and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation. If this equipment does cause harmful interference to radio or television reception,

which can be determined by turning the equipment oﬀ and on, the user is encouraged to try to correct the

interference by one or more of the following measures:

Reorient or relocate the receiving antenna.

Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit

diﬀerent from that to which the receiver is connected.

Consult the dealer or an experienced radio/TV technician for help.