Wistron NeWeb DRMR81 802.11 b/g mini-PCI WLAN Module User Manual

Download:
Mirror Download [FCC.gov]
Document ID	974047
Application ID	rc+fCc0u0lXVYENq7uWCyw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	17.28kB (215964 bits)
Date Submitted	2008-07-22 00:00:00
Date Available	2008-07-22 00:00:00
Creation Date	2008-07-21 17:04:36
Producing Software	Acrobat Distiller 7.0 (Windows)
Document Lastmod	2008-07-21 17:11:00
Document Title	Microsoft Word - User's manual for DRMR-81 2008_07_14.doc
Document Creator	PScript5.dll Version 5.2
Document Author:	Jolin

802.11b/g mini-PCI WLAN Module
User’s Manual
July. 2008
Copyright Statement
No part of this publication may be reproduced, stored in a retrieval system, or transmitted in any
form or by any means, whether electronic, mechanical, photocopying, recording or otherwise
without the prior writing of the publisher.
Windows™ 98SE/2000/ME/XP are trademarks of Microsoft® Corp.
Pentium is trademark of Intel.
All copyright reserved.
FCC Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause
harmful interference to radio or television reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to correct the interference by one of the
following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: To assure continued compliance, (example - use only shielded interface cables
when connecting to computer or peripheral devices) any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
This device may not cause harmful interference, and
This device must accept any interference received, including interference that may cause
undesired operation.
Important Note
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
Country Code Statement
For product available in the USA/Canada market, only channel 1~11 can be
operated. Selection of other channels is not possible.
如果這一個 module 沒有限定在特定的 host，只要是 Mobile 即可的話
IMPORTANT NOTE:
This module is intended for OEM integrator. The OEM integrator is still
responsible for the FCC compliance requirement of the end product, which
integrates this module.
20cm minimum distance has to be able to be maintained between the antenna
and the users for the host this module is integrated into. Under such
configuration, the FCC radiation exposure limits set forth for an
population/uncontrolled environment can be satisfied.
Any changes or modifications not expressly approved by the manufacturer could
void the user's authority to operate this equipment.
USERS MANUAL OF THE END PRODUCT:
In the users manual of the end product, the end user has to be informed to keep
at least 20cm separation with the antenna while this end product is installed and
operated. The end user has to be informed that the FCC radio-frequency
exposure guidelines for an uncontrolled environment can be satisfied. The end
user has to also be informed that any changes or modifications not expressly
approved by the manufacturer could void the user's authority to operate this
equipment. If the size of the end product is smaller than 8x10cm, then additional
FCC part 15.19 statement is required to be available in the users manual: This
device complies with Part 15 of FCC rules. Operation is subject to the following
two conditions: (1) this device may not cause harmful interference and (2) this
device must accept any interference received, including interference that may
cause undesired operation.
LABEL OF THE END PRODUCT:
The final end product must be labeled in a visible area with the following "
Contains TX FCC ID: NKRDRMR81 ". If the size of the end product is larger than
8x10cm, then the following FCC part 15.19 statement has to also be available on
the label: This device complies with Part 15 of FCC rules. Operation is subject
to the following two conditions: (1) this device may not cause harmful
interference and (2) this device must accept any interference received, including
interference that may cause undesired operation.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated with
minimum distance 20cm between the radiator & your body.
Chapter 1 Introduction
Thank you for purchasing this 802.11b/g mini-PCI WLAN Module that provides the easiest way to
wireless networking. This User’s Manual contains detailed instructions in the operation of this
product. Please keep this manual for future reference.
Features
RoHS compliance
Operation temperature -25~70oC
High speed for wireless LAN connection: IEEE802.11b 11Mbps data rate by incorporating
Direct Sequence Spread Spectrum (DSSS); IEEE802.11g 54Mbps date rate with OFDM
and 11Mbps with DSSS.
Data Rates: 1, 2, 5.5, 6, 9, 11, 12, 18, 24,36, 48, & 54Mbps.
Modulation OFDM with BPSK, QPSK,16QAM, 64QAM.
DBPSK, DQPSK, CCK.
Mini PCI type IIIA form factor.
Site survey function.
Chapter 2 Installation
Follow the steps below to complete the installation:
1. Execute
IS_AP_STA_6x_D-1.2.3.0_VA-2.1.0.0_2500_D-3.2.0.0_VA-3.2.0.0_RU-2.0.4.0_VA-2.0.4.0_
AU-1.2.1.0_VA-1.0.4.0_101707_0.1.0.29.EXE
2. Click “Next”.
10
3.
Select “Ralink Configuration Tool”.
11
4. Select “Optimize for WiFi mode”.
12
5. “Select “SETUP”.
13
6. The hardware installation is completed.
14
Chapter 3 Connecting to a Network
1. Double click the shortcut icon of Ralink Wireless Utility on the desktop, and the RaUI
Wireless Network Connection Status’ window appears.
2. Select “View Wireless Networks” and check the available networks.
15
3. From the list of “Available Networks”, choose one network by clicking the “add connection
setup”.
4. You can either select “Unsecured wireless network” or “Security-enabled wireless network”.
You need the appropriate username and password to use a “Security-enabled wireless
network”.
16
Chapter 4 Specification
Please refer to the other document - approval spec.
17

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : No
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print, Extract, Print high-res
XMP Toolkit                     : 3.1-701
Producer                        : Acrobat Distiller 7.0 (Windows)
Creator Tool                    : PScript5.dll Version 5.2
Modify Date                     : 2008:07:21 17:11+08:00
Create Date                     : 2008:07:21 17:04:36+08:00
Metadata Date                   : 2008:07:21 17:11+08:00
Format                          : application/pdf
Title                           : Microsoft Word - User's manual for DRMR-81 2008_07_14.doc
Creator                         : Jolin
Document ID                     : uuid:ce05f128-0ac0-4dab-b6b0-c83767129a04
Instance ID                     : uuid:fc0695e3-ab6e-47c1-bd53-3d9287410610
Page Count                      : 17
Author                          : Jolin

EXIF Metadata provided by EXIF.tools