Wistron AL5230S 5G Wireless Audio Transceiver Module, 5G Wireless Audio Receiver Module User Manual Manual 20130927

Download:
Mirror Download [FCC.gov]
Document ID	2085038
Application ID	B2WTz90k7a6yLFHgDyU7gQ==
Document Description	user manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	6.83kB (85420 bits)
Date Submitted	2013-09-28 00:00:00
Date Available	2013-09-28 00:00:00
Creation Date	2013-09-27 19:14:34
Producing Software	Acrobat Distiller 9.0.0 (Windows)
Document Lastmod	2013-09-27 19:14:34
Document Title	Microsoft Word - Manual 20130927
Document Creator	PScript5.dll Version 5.2.2
Document Author:	Elaine

5G Wireless Audio Transceiver/Receiver Module
WLL7010-D20(RoHS)/WLL7011-D20(RoHS)
1.
Module dimensions and layout
2.
Feature:
DARR83 Wireless Audio Processor
5.2/5.8GHz RF Transceiver / Receiver
Embedded antennas
Digital audio interfaces (I2S and/or S/PDIF)
I2C control interface
26 pins header connector for power, digital audio and control interface and
GPIOs
Built‐in 1MB SPI interface Flash
3.
How to use this module
WLL7010‐D20(RoHS)/WLL7011‐D20(RoHS) was design for transfer audio signal
use, while user turn on the power of the Host device. (For example,
SoundBar/woofer or other mobile device), WLL7010‐D20(RoHS) /
WLL7011‐D20(RoHS) will pair automatically, and transfer audio signal by the
radiated signal.
4.
Pin assignmen:
The device can be configured as below:
Pin
TX
RX
3.3V
3.3V
GND
GND
MCLK
MCLK
RF_Pairing _btn
AM_IFO
Pairing_LED
24V_ENABLE
INT
PAIRING_LED
MUTE
EN_BUF
Quick suspend
AMP_RST
DARR83_GPIO_3
I2C SDA MST
10
DARR83_GPIO_15
I2C SCL MST
11
GND
GND
12
GND
GND
13
DARR83_GPIO_24
(MON_TXD)
RF_PAIR_BTN
14
DARR83_GPIO_14
POWER_SB
15
DARR83_GPIO_16
MON_TXB
16
NC
NC
17
RF_ENABLE
RF_Reset
18
I2C SCL SLV
NC
19
I2C SDA SLV
NC
20
DARR83_GPIO_12 (Z)
DE_5V
21
DARR83_GPIO_11 (X)
DEV_3V3
22
DARR83_GPIO_10_LRCK
DAO1_LRCLK_RF
23
GND
GND
24
DARR83_GPIO_8_SCLK
DAO1_SCLK_RF
25
DARR83_SR_RF (Y)
DAO1_SR_RF
26
DARR83_SUB_MIX (W)
DAO1_SUB_MIX_RF
Federal Communication Commission Interference
Statement
This equipment has been tested and found to comply with the limits for a Class
B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or more of
the following measures:




Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the
party responsible for compliance could void the user's authority to operate this
equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This device and its antenna(s) must not be co-located or operating in
conjunction with any other antenna or transmitter.
IMPORTANT NOTE:
FCC Radiation Exposure Statement:
This equipment complies with FCC radiation exposure limits set forth for an
uncontrolled environment. This equipment should be installed and operated
with minimum distance 20cm between the radiator & your body.
This device is restricted to indoor use when operated in the 5.15 to 5.25 GHz
frequency range.
The final end product must be labeled in a visible area with the following "
Contains TX FCC ID: PU5AL5230S".

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : Elaine
Create Date                     : 2013:09:27 19:14:34+08:00
Modify Date                     : 2013:09:27 19:14:34+08:00
XMP Toolkit                     : Adobe XMP Core 4.2.1-c043 52.372728, 2009/01/18-15:08:04
Creator Tool                    : PScript5.dll Version 5.2.2
Producer                        : Acrobat Distiller 9.0.0 (Windows)
Format                          : application/pdf
Title                           : Microsoft Word - Manual 20130927
Creator                         : Elaine
Document ID                     : uuid:5d2da28a-5114-40b2-be6d-275d7613e61d
Instance ID                     : uuid:a8f21e6d-e915-48d6-afa2-b78659419f4f
Page Count                      : 4

EXIF Metadata provided by EXIF.tools