Wonders Technology DS1771 Wireless Bluetooth Speaker User Manual FH333043 DS 1771

Wonders Technology Co., Ltd. Wireless Bluetooth Speaker FH333043 DS 1771

user manual

1 25 6 73 4+Long press: Skip next Short press:Volume up.Long press: Skip previous Short press:Volume down.242. Mode indicator press PresspresspressPressLine in576Reset portSoundBox ColorSoundBox ColorEnable Bluetooth on your device and choose DOSS Soundbox Color from the list. BluetoothQuick fSlow flashing blueMode indicatorIf pairing is successful, the LED will change to a slow flashing blue and your phone will confirm that the connecon has been established. If the pairing process fails aer 60 seconds, please repeat the above steps 1 through 5. 7.4 x 3 x1.9inch6W x 275dB80Hz-20KHz1.06lbWonders Technology Co.,LtdEmail:Support@dossav.comWebsite:www.dossaudio.com Follow us on Facebook: Using it with your Amazon Echo Dot1.Switch the CloudFox speaker to Bluetooth mode,you can press the ‘play/pause’ buon for 3 seconds to keep it in pairing status.2.Run the Alexa app, tap ‘Connue’ and Select Bluetooth .3.4.Speaker's baery will have to be charged at least 8-10 hours prior to first use. Moving forward, the baery will only take 3 hours to recharge. Place your smart device and wireless speaker no more than 3 feet away from each other. Upon powering on, a tone will be heard along with a flashing blue LED light also accompanied by a prompt noficaon that the speaker has entered into pairing mode. To end a call, tap the buon once again. You may also end the call directly via your cell phone.You can connect the Amazon Echo Dot with the speaker via 3.5mm Aux-in cable or via Bluetooth. Here is how to connect via Bluetooth: The DOSS Soundbox Color speaker should appear in the list of Bluetooth devices. If not, press the "Play/Pause" buon for 3 seconds and try again. If you see our device listed, please tap it to complete the pairing process. Download the Amazon Alexa App, follow the standard setup procedure to get the Echo dot connected to your home Wi-Fi.If a call was received while listening to music, playback will resume automacally once the call has ended.BluetoothProblem SoluonothersNot paired with Bluetooth transmierCannot Pair with Bluetooth devicesPress Play/Pause buon for 3 seconds,then have a try to pair it again.Cannot play music aer pairing with the laptopPlease select 'DOSS SoundBox Color' as the default playback device.The song cuts off during playbackPlease check if the Bluetooth distance is more than 33 feet or the baery level is low.There is noise during playbackLaptop prompts to install driverThis driver is not special for SoundBox Color,it's for your laptop Bluetooth funcon, please contact the computer company or windowsCannot turn off the speakerCustomer Service Email support@dossav.comUse the needle or wire to poke the reset port DOSS SoundBox ColorPlease press Play/ Pause buon for 3 seconds or contact with the transmier' s customer service for helpTroubleshoong:Could be caused by the interference of charging. Try changing the locaon of the device and do not charge it during playback. topVolume/Track control:NOTE: Your voice command cannot turn on/off the DOSS SoundBox Color no maer you are connected via Bluetooth or Aux-in cable. It can only transfer sound signals. Steady greenFCC Statement:This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the followingmeasures:—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.Caution: Any changes or modifications not expressly approved by the party responsiblefor compliance could void the user's authority to operate the equipment.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter.

Navigation menu