Wonders Technology WB60 Outdoor Waterproof Bluetooth Speaker User Manual DS 1681 5PCS

Wonders Technology Co., Ltd. Outdoor Waterproof Bluetooth Speaker DS 1681 5PCS

user manual

Outdoor Waterproof Bluetooth SpeakerMode No.: DOSS Traveler User Manual Status indicatorsII. Package contentIII. Product overview7. Auxiliary Φ3.5mm jack : Use it for cabled playback with compable devices.11. TF card: Use it for TF card (with music) playback.9. Charging port: Plug the supplied USB cable into this port to recharge8. LED charging indicator.• Charging : Steady Red.• Fully charged : Steady Green.10. Reset mode: Reset speaker when it can't work.• Outdoor waterproof speaker x 1• USB charging cable x 1• Φ3.5mm auxiliary cable x 1• Handle belt x 2• User manual x 11.2.Indicator: Different lights indicate different modes. Press 3 seconds to turn the device on or off.3.Mode switch: Short press to toggle play mode among Bluetooth, 5. Play/Pause: •In Bluetooth mode, press to play/pause your tune. Press for 3seconds to disconnect with your device.•In TF mode, press to play/pause your tune.6. Volume/Track control:• Short press to decrease the volume.Long press to skip previous song.• Short press to increase the volume. Long press to skip next song.4. Light mode: Short press to switch four different lights. Low brightness, Medium brightness, High brightness, SOS(emergency signal).Center indicator/indicatorFlashing blue Steady blue Steady redSteady greenIndicates that the speaker has entered into the pairing mode and it is ready to be Indicates that the device is successfully pairedSteady red Steady GreenIndicates that the device has switched to the auxiliary input modeIndicates that the device has switched to the TF mode 132 456Reset7 8 9 10 11V. Pairing the wireless speaker with your smart deviceVI. Answering and ending a call using your speaker ormobile phone• Use the supplied USB cable to charge your portable speaker directlyfrom your computer or device with a micro USB port.• Make sure that the speaker is fully charged before using it for thecapacity, the LED will change to green.3seconds. the device.1. Place your smart device and wireless speaker no more than one meteraway from each other.several seconds to turn it on.3. Set your smart device to “discover” the wireless speaker. Uponpowering on, a tone will be heard, the blue LED will start flashing,the pairing mode.4. Enabled Bluetooth on your device and choose DOSS CloudFox Sportfrom the list.5. If pairing is successful, the LED will change to steady blue and your5 described above.1. When there is an incoming call, the speaker will generate a tone and Briefly press the Handset buon to pick up, long press to reject. You may also press the answer buon on your phone to take the call using the speaker.2.Product type: Outdoor Waterproof Bluetooth Speaker Output power: 10W x 2Driver unit: 1.7 inch speaker x 2 + 2.6 inch passive radiatorFrequency response: 65Hz-18kHzUnit weight: 600 gUnit dimension: 6.50x 4.45 x 2.24 inchWarranty: One-year limitedVIII. PowerX. WarningIX.Wireless/Networking• Input:5V 2A Bluetooth versions• Profiles supported•••• Do NOT disassemble, repair or modify the Bluetooth speaker by yourself.• Do NOT use cleaning products that contain benzene, solvents or alcohol.• Do NOT place heavy objects on top of the Bluetooth speaker.• Do NOT use near a microwave oven or wireless LAN products.Using it with your Amazon Echo DotYou can connect the Amazon Echo Dot with the speaker via 3.5mm Aux-in cable or Bluetooth, here is how to set up laer oponWonders Technology Co.,LtdEmail:Support@dossav.comFollow us on Facebook: Signal to noise rao: 50dB7.4•In Bluetooth mode, press to answer or end a call. Press for 3 seconds to reject a call.• Thank you for purchase DOSS Traveler Portable Wireless Bluetooth Speaker with Bluetooth and Waterproof function. We encourage you to read this instruction guide thoroughly to get the most out of this innovative wireless portable speaker.Download the Amazon Alexa App, follow the standard setup procedure to get the Echo dot connected to your home Wi-Fi. 1.Switch the CloudFox speaker to Bluetooth mode,you can press the ‘play/pause’ buon for 3 seconds to keep it in pairing status.2.Run the Alexa app, tap ‘Connue’ and Select Bluetooth .3.The DOSS CloudFox speaker should appear in the list of Bluetooth devices. If no that, press the ‘play/pause’ buon for 3 seconds and try again. When it does, tap it to complete the pairing process. 4.Note: Whatever you connect it via Bluetooth or Aux-in cable,your voice command cannot turn on/off the DOSS CloudFox,that can only transfer sound signal.5.Connect Echo Dot to DOSS CloudFox using an Aux-in cable.3. Speak with a clear voice right into the built-in microphone located onTo end a call, tap the Handset buon once again. Likewise, you may also end the call directly using the command on your cell phone.4.5. When listening to music using your smart phone, playback will resume 2.1. Waterproof, Shockproof, Dustproof Rated IP67 for 100% protecon against Water and Dust. Rubberized rugged exterior for ulmate impact resistance. Water-resistant HD loudspeaker, and splash-proof surface to increase mobility and usability for everyday indoor or outdoor use such as shower, beach, pool, boat, bathroom, car, office, and much more!VII. Features and probleModes: high brightness; medium brightness; low brightness; SOS (emergency signal)3.BluetoothProblem SoluonTF CardotherCannot Pair with Bluetooth devicesPress Play/Pause buon for 3 seconds,then have a try to pair it again.Cannot play music aer pairing Please select 'DOSS CloudFox Sport' as the default playback device.The song cuts off during playbackPlease check if the Bluetooth distance is more than 33 feet or the baery level is low.There is noise during playback Maybe caused by the interference of charging,try to put it in another place and do not charge it during playbackLaptop prompts to install driver This driver is not special for CloudFox Sport,it's for your laptop Bluetooth funcon, please contact the computer company or windowsNot paired with transmierThe speaker do not play when the card is inserted,and jump directly back to Bluetooth mode.Check whether the card format is FAT or FAT32. If not, format it to FAT or FAT32.Check the song format. The speaker only supports MP3, WAV, WMV.The song cuts off during playback.All the lights are lit and can not be turned offCustomer Service Email support@dossav.comUse the needle or wire to poke the reset buon inside Aux-inThere may be a problem with the song's file, try deleng all the songs in the same file.Please press Play/ Pause buon for 3 seconds or contact with the transmier' s customer service for helpTrouble Shoong:Quick ps about how to use handle belts:Undo the two nuts counter-clockwise on the strap.Remove the nuts from the straps, then put the strap through the strap buckle.Tighten the screw clockwise on the strap.10.6 in65.0 inFCC Statement:This device complies with part 15 of the FCC Rules. Operation is subject to the followingtwo conditions: (1) This device may not cause harmful interference, and (2) this devicemust accept any interference received, including interference that may cause undesiredoperation.This equipment has been tested and found to comply with the limits for a Class B digitaldevice, pursuant to part 15 of the FCC Rules. These limits are designed to providereasonable protection against harmful interference in a residential installation. Thisequipment generates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions, may cause harmful interference to radiocommunications. However, there is no guarantee that interference will not occur in aparticular installation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off and on, theuser is encouraged to try to correct the interference by one or more of the followingmeasures:—Reorient or relocate the receiving antenna.—Increase the separation between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which thereceiver is connected.—Consult the dealer or an experienced radio/TV technician for help.Caution: Any changes or modifications not expressly approved by the party responsiblefor compliance could void the user's authority to operate the equipment.This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.This transmitter must not be co-located or operating in conjunction with any other antenna ortransmitter.

Navigation menu