Worx Tools Aerocart Wagon Wa0228 Users Manual

: Worx-Tools Worx-Tools-Aerocart-Wagon-Wa0228-Users-Manual-478367 worx-tools-aerocart-wagon-wa0228-users-manual-478367 worx-tools pdf

Open the PDF directly: View PDF .
Page Count: 2

WA0228

HELPLINE NUMBER

1-866-354-WORX (9679)

HELPLINE NUMBER

54

6 7

1

2

3

1

2

5

3

4

A1

A2

A3

1

2

3

1

2

3

4

5

6

B

C1

C2

2

1

D

E

F

300lbs/136kg

300lbs/136kg

300lbs/136kg

I

II

III

Wagon Kit ENWagon Kit EN

Wagon Kit ESWagon Kit ES

Wagon Kit F

Copyright © 2014, Positec. All Rights Reserved.

Made in China

Fabriqué en Chine

Fabricado en China

GENERAL SAFETY WARNINGS

WARNING: Read all safety warnings and all

instructions. Failure to follow the warnings and

instructions may result in serious injury.

Save all warnings and instructions for future reference.

WARNING: This product may contain lead,

phthalate or other chemicals known to the

State of California to cause cancer, birth defects

and other reproductive harm. Please wash your

hands after use.

1) Operators should be aware of and minimize the

following hazards:

– Running the cart’s wheels off of bridge/dock plates,

dock platforms, uneven surfaces, or inclines;

– Colliding with other carts or obstructions. Secure the

load and close containers to prevent losing control of

the load while moving;

– Jamming of the operator’s hands between the cart

and other objects;

– Running the cart’s wheels over the operator’s feet;

2) Keep pneumatic tires at the rated pressure and check

often.

3) Carts used for transporting chemicals should have

rails to prevent chemicals from falling off the cart.

4) Inspect carts routinely and do not use them if they are

not in good repair.

5)

Check the tires to make sure they are properly inflated.

6) Maintain adequate visibility. Do not stack materials

beyond a safe height or in a manner that obstructs

vision. Pay attention to the path of travel and do not

move too fast.

7) Do not exceed the manufacturer’s recommended

load limits. Be aware of lifting/bending and other

ergonomic hazards when using carts. Avoid heavy

loads that require excessive force to move, do not

twist while moving a cart, and be alert to terrain

hazards that can cause the cart to shift or stop

abruptly (e.g., cracks, dips, uneven surfaces, etc.).

8) Ensure that the load is not wider than the cart,

especially when traveling in narrow halls and

doorways. Do not forget the stationary mullion in

double doorways.

9) Do not try to navigate carts on stairs or steep inclines.

10) When not in use, carts should be parked in a

designated area, not in aisles or other places where

they cause trip hazards, block traffic, breaker boxes,

and fire extinguishers and pull stations, eyewash

stations, or other safety equipment.

11) Carts with drawbar handles should be parked with

handles up and out of the way. Two‐wheeled carts

should be stored upright with handles leaning against

a wall.

12) Do not sit or stand on the hand cart.

Four-wheeled Hand Cart Safety Warnings

1) Place loads evenly to prevent tipping.

2) Carts should be pushed rather than pulled except for

those with a fifth wheel and a handle for pulling.

1. Handle

2. Handle Shaft

3. Hay Wagon Clip

4. Wheel

5. Wagon Axle Body

6. Tray

7. Seat

MAX LOADING

Wagon Cart 300lbs (136kg) See Fig. I

Hay Wagon 300lbs (136kg) See Fig. II

Seat 300lbs (136kg) See Fig. III

SYMBOLS

Incorrect

Correct

Lock

Unlock

Use spanner

ASSEMBLY & OPERATION

Action Figure

Attaching the Wagon Axle Body

to the AerocartTM

See Fig. A1, A2, A3

Attaching Wheels

See Fig. B

Attaching Handle

See Fig. C1,C2

Wagon Cart

See Fig. D

Hay Wagon

See Fig. E

Seat

See Fig. F

ASSEMBLY

Attaching the Wagon Axle Body to the AerocartTM

(See Fig. A1, A2, A3)

• PositiontheAerocartTM into dolly mode (standing

upright, with legs folded down)

• RotatetheHandleLockingLeversontheAerocartTM to

unlock.

• RemovetheHandlesfromtheAerocartTM.

• HoldtheWagonAxleBodyandapproachtheCart

horizontally. Engage the slots on the end of the tubes

with the knobs on both sides of the AerocartTM.

• RotatetheWagonAxleBodyupwardsuntilvertical.

Make sure the locking pin holes have aligned with the

handle locking pins.

• RotatetheHandleLockingLeverstosecuretheWagon

Axle Body in place.

Attaching Wheels (See Fig. B)

• Removethenutfromtheaxleshaftusingthespanner

wrench provided.

•

Align the wheel so that the concave rim faces outward.

• SlidethewheelontotheshaftoftheWagonAxle

Body and secure in place using the supplied nut and

spanner wrench.

• RepeatonothersideofWagonAxleBody.

Attaching Handle (See Fig. C1,C2)

• AligntheholesontheWagonHandleandtheWagon

Handle Shaft and slide them into each other.

• Secureinplaceusingthesuppliednut,bolt,and

washer.

• AttachtheWagonHandletothetongueoftheWagon

Axel Body by aligning the holes and then securing in

place using the supplied nut and bolt.

OPERATION

The AerocartTM can be transformed into a wagon with

four wheels.

Wagon Cart (See Fig. D)

• PlacetheTrayintheWagonAxleBody,andmakesure

it is fully secured.

Hay Wagon (See Fig. E)

The Hay Wagon mode may be used for carrying large or

more objects.

• LifttheExtensionArms.

• InserttheHandlesoftheAerocartTM into the Hay

Wagon Clips.

Seat (See Fig. F)

• MakesuretheAerocartTM is on stable ground.

• PlacetheSeatontheAerocartTM so that the grooves

are on the rim of the AerocartTM’s body.

• ConrmtheSeatisstablebeforesittingonit.

NOTE: The Seat supplied with the Wagon Cart is

different from the Seat supplied with the AerocartTM

model WG050.1.