Wyse Technology WT9450 Windows-Based Terminal User Manual

Wyse Technology Windows-Based Terminal 883753 01A Website2

a href="https://usermanual.wiki/Wyse-Technology" itemprop="url"> Wyse Technology >

Contents

Installation guide

NOTES: QUICK START GUIDEI’ve attached a draft of the Quick Start Guide for Model WT9450XE. The final edition will be the same asthis document, except for the following modifications:• Photographs on pages 1 and 2 will be replaced with those of Model WT9450XE.• Back Panel Connectors chart on page 2 will be updated.The existing text, including the Power Source information and the ferrite bead installation instructions, willremain in the WT9450XE Quick Start Guide.
Winterm™ Model 9450XE XPE-Based TerminalQuick-Start Guide➊Connect – Caution: Improper connection, mounting, or use of this product could result in component failure and/or flash memory corruption. Read the following caution statements before setting up and operating the terminal.Cautions:Setup• Do not connect power until all other connections are made. Connecting or disconnecting components or devices on the back panel when the terminal is receiving power can cause power surges and damage the terminal. (USB ports are hot-swappable.)• Do not force a connector into its socket. If any undue resistance is encountered, ensure that the connector is correctly oriented to the receptacle.Orientation and Venting• Mount the terminal only as shown above or in accordance with the instructions provided with the Wyse-approved wall mount (see Note below). Improper orientation (such as component side down, where the back panel’s symbols are upside down) could inhibit the dissipation of heat from the terminal and damage it.• Allow sufficient space around the terminal for ventilation; do not place the terminal in any enclosure that restricts airflow around the terminal; do not place any objects on the terminal. Product environmental specifications are available through Wyse’s Web site at http://www.wyse.com/products/winterm/products.htm.Power Sources• To ensure regulatory compliance, use only the power supply included in the shipping box, or a Wyse-approved equivalent, with the terminal. Also, the noise suppressor (ferrite bead) included in the box with the terminal must be installed on the network cable as described following these caution statements. Refer to the regulatory notices in the terminal’s on-line documentation at http://www.wyse.com/products/winterm/quickstart/9000.htm.• To prevent accidental loss of power, brown out, and spikes which could damage the terminal, avoid connecting it to any form of switching device (including power strips) or hard resetting the terminal by holding down the power button.• When turning off the terminal, be sure to perform a complete shutdown (via the user interface or power button); do not disconnect the power cord, shut off power at a circuit breaker, etc., to turn off the terminal.Note: Visit http://www.wyse.com/products/accessories/mounting.htm for information about approved wall-mount and monitor-mount accessory kits.*Supplied for U.S.A.; in other locales, check package contents or contact your Wyse reseller.
Download:
Mirror Download [FCC.gov]
Document ID274808
Application ID87JAGp3Meuq74NcANSxmTw==
Document DescriptionInstallation guide
Short Term ConfidentialNo
Permanent ConfidentialNo
SupercedeNo
Document TypeUser Manual
Display FormatAdobe Acrobat PDF - pdf
Filesize20.11kB (251423 bits)
Date Submitted2002-10-04 00:00:00
Date Available2002-10-04 00:00:00
Creation Date2002-09-26 17:29:24
Producing SoftwareAcrobat Distiller 5.0.5 (Windows)
Document Lastmod2002-09-26 17:05:29
Document Title883753-01A Website2.fm
Document CreatorADOBEPS4.DRV Version 4.50
Document Author: mraboy
FCC ID Filing: DYDWT9450

Navigation menu