XAC Automation C150 Contactless card reader User Manual

XAC Automation Corporation Contactless card reader

User Manual

 CONTACTLESS READER MODULE C150 INSTALLATION GUIDE
1. IN THE BOX C150 (Figure 1) with USB, RS232 and custom cable If it’s a RS232 cable, the power jack is on the rear of the DB9 connector. Connect the power cord of the adaptor with the power jack on the rear of the cable (Figure 2) If it’s a USB cable (Figure 3), it will get the power from USB connected Host If it’s a custom cable (Figure 4), it will get the power from custom’s device. Figure 1 Figure 2 Figure 3 Figure 4 2. SETTING CONNECTION USB interface Plug the USB connector into any of the USB port of the terminal. RS232 interface Connect the RS232 connector with the COM port of the terminal. 3. INSTALLING THE SAM CARD Loosen the screw and open the SAM gate (Figure 4), insert the SAM card in the slot (Figure 5). Figure 4 Figure 54. USING CONTACTLESS CARD READER Contactless reader antenna is around the display. It will light up and blinking the 1st LED when C150 is powered on and that means reader is working normally. Place contactless card near the display (Figure 6). The contactless antenna should detect the card and read the card data. Figure 6
CAUTIONS AND WARNINGS Risk of explosion if the battery is replaced by an incorrect type. Dispose of used batteries according to the instructions. FEDERAL COMMUNICATION COMMISSION INTERFERENCE STATEMENT This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:‐ Reorient or relocate the receiving antenna. ‐ Increase the separation between the equipment and receiver. ‐ Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. ‐ Consult the dealer or an experienced radio/TV technician for help. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This transmitter must not be co-located or operating in conjunction with any other antenna or transmitter. INDUSTRY CANADA STATEMENT This device complies with RSS-210 of the Industry Canada Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Ce dispositif est conforme à la norme CNR-210 d'Industrie Canada applicable aux appareils radio exempts de licence. Son fonctionnement est sujet aux deux conditions suivantes: (1) le dispositif ne doit pas produire de brouillage préjudiciable, et (2) ce dispositif doit accepter tout brouillage reçu, y compris un brouillage susceptible de provoquer un fonctionnement indésirable. 
The above information is the exclusive intellectual property of XAC Automation Corporation and shall not be disclosed, distributed or reproduced without permission of XAC Automation Corporation. XAC AUTOMATION CORP. shall not be held liable for technical and editorial omissions or errors made herein; nor for incidental or consequential damages resulting from the furnishing, performance or use of his material. XAC Automation Corporation 886-3-577-2738 www.xac.com.tw

Navigation menu