XShot 918569 AUTODYNE DEVICE User Manual BX88 569

XShot, Inc. AUTODYNE DEVICE BX88 569

Users Manual

User Manual 1、The power switch to the "ON", as shown in the following figure, the device enters pairing state,Then the LED slow flash. Pictured above, in "OPEN" direction of rotation Battery battery cover, can remove the battery cover to replace the CR2032 battery, replace the installed back battery cover and rotated in reverse direction. 2、And the mobile phone the pairing is successful, open mobile phone camera interface, click "Key" button, as shown in the following figure, equipment issued "VOL+" code for IOS, pictures for apple, Huawei and mobile phone OPPO etc.. 3、Long press "Key" button for 3 seconds to equipment, LED light, open the "Key" button, and then light the "Key" key, equipment issued "PLAY" code of IOS, suitable for coolpad, Samsung mobile phone camera.
Federal Communications Commission (FCC) Interference Statement This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generate, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one of the following measures:  Reorient or relocate the receiving antenna.  Increase the separation between the equipment and receiver.  Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.  Consult the dealer or an experienced radio/TV technician for help. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1)This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate this equipment. RF exposure warning This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment. The equipment must not be co-located or operating in conjunction with any other antenna or transmitter.

Navigation menu