Yamaha NS AP7800M Owner's Manual AP7800

If not then NS-AP7800_manual Manual: ://www.yamaha.com/yamahavgn/s/YEC/Speakers/Manual/NS-AP7800_manual

User Manual: Yamaha NS-AP7800M Owner's Manual

Open the PDF directly: View PDF PDF.
Page Count: 8

DownloadYamaha NS-AP7800M Owner's Manual NS-AP7800
Open PDF In BrowserView PDF
NS-AP7800M/NS-AP7800E
HOME CINEMA SPEAKER PACKAGE

CONTENTS
CONSUMER PRECAUTIONS ............................................................................ 2
UNPACKING .......................................................................................................3
SETTING UP THE SPEAKERS .......................................................................... 4
CONNECTIONS TO THE RECEIVER ................................................................ 6
SPEAKER PLACEMENT .................................................................................... 7
SPECIFICATIONS ...............................................................................Back cover

OWNER’S MANUAL

NS-AP7800M/NS-AP7800E

CONSUMER PRECAUTIONS
Read these precautions carefully before operating your NS-AP7800 speakers.


Since these speakers can be wall mounted, it is essential that they are firmly secured. Be sure to consult a
reliable source about the best type of hanger for your particular wall’s construction. Secure installation is the
purchaser’s responsibility.



Do not attach them to thin plywood or soft wall surface materials as the screws may tear free, causing the
speakers to fall and be damaged, or result in personal injury.



Do not fasten the speakers to walls with nails, adhesives, or other unsafe hardware. Long-term use and
vibrations may cause them to pull free.



Do not place the speakers where they are liable to be knocked over or struck by falling objects. Stable
placement will also ensure better sound performance.



Placing the speakers on the same stand or shelf as a turntable can result in feedback.



This speaker features a magnetically shielded design, but there is still a chance that placing it too close to a
TV set might impair picture color. Should this happen, move the speaker away from the TV set.



Never touch the woofer or tweeter units with your hands or expose them to excessive physical shock. If they
are dented or bent, the sound will be distorted.



Lower the power amplifier / receiver volume control before changing input sources. Never change input
sources (for example, FM to CD) at high listening levels. Always turn the receiver / amplifier unit off when
installing or removing input cables.



Anytime you note distortion, reduce the volume control on your power amplifier / receiver to a lower setting.
Never allow your power amplifier to be driven into “clipping”.



Do not attempt to clean the speakers with chemical solvents as this might damage the finish. To clean wipe
with a dry, soft cloth.



To prevent the enclosure from warping or discoloring, do not place the speakers where they will be exposed to
direct sunlight or excessive humidity.



To prevent the speakers from falling over, select a location which is flat and stable.



To avoid accidents resulting from tripping over loose speaker cables and to prevent the speakers from falling,
fix the speaker cables to the wall, etc.



Secure placement or installation is the owner’s responsibility.
YAMAHA shall not be liable for any accident caused by improper placement or installation of speakers.

2

NS-AP7800M/NS-AP7800E

UNPACKING
After unpacking, check that following items are contained.
Front speaker x 2

Center speaker x 1

(NS-AP7800C)
Surround speaker x 2

(NS-AP7800S)

(NS-AP7800F)
Pedestal x 2 (for front speaker)

Rubber base x 2 (for center speaker)

Screws x 6 (Ǟ4 x 40 mm for pedestals)

Double-sided adhesive tape x 2
(for center speaker)

Speaker cable x 1 (80 feet)

Fastener x 2 (for center speaker)

Wall mounting rubber pads 4 pcs x 2
(for surround speakers)

Non-skid pads 5 pcs x 2
(for front speakers)

(Ǟ10 x 5 mm)

(Ǟ15 x 2 mm)

3

NS-AP7800M/NS-AP7800E

SETTING UP THE SPEAKERS


Attaching the pedestals to the front speakers

Attach the pedestal to the front speaker as shown below by using screws supplied with the product.
Non-skid pad
Screw
Philips driver

Bottom of the
front speaker


Pedestal

Non-skid pads

Wall mounting the surround speakers

When mounting the speakers on a wall, attach one of the wall mounting rubber pads provided near each of the
corners on the rear surface of the speaker to prevent the speaker cable from being caught between the wall
and the speaker.
You can also use the screw holes on the back of the speaker for
installing the speakers on commercially available speaker brackets.
3-11/16” (93.5 mm)

Wall / wall support

7-1/4” (184 mm)

10” (254 mm)

A screw with a diameter of
1/4” can be used.
(Hole depth: 9/32”)
2-3/8” (60 mm)

2

Min
1”
7/32”

1

Tapping screw
(Available at the hardware store)

When using speaker brackets to mount the speakers on a wall or ceiling, it is strongly recommended that
safety wire, which may be included with the bracket, be used between the speaker and the bracket to prevent
the speaker from falling.

Fasten screws into a firm wall or wall support as shown in the figure, and hang the holes of the mounting
bracket on the protruding screws.
Make sure that the screws are securely caught by the narrow sections of the “key hole” opening.
WARNING






4



Surround speaker weighs 3.53 lbs (1.6 kg). Do not mount the speakers on thin plywood or a wall with soft
surface material, since the screws may pull away from the surface and fall. This will damage the speakers
and can cause personal injury.
Do not mount the speakers on a wall with nails, adhesives, or any other unstable hardware. Long-term use
and vibrations may cause them to fall.
To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.
Secure installation is the purchaser's responsibility.

NS-AP7800M/NS-AP7800E



Placing the center speaker

Place the speaker on the TV or inside the TV rack
so that it is stabilized.

side view



Placing the center speaker on top of the
TV

Affix the supplied fasteners to the bottom of the
rubber bases. Peel off the seal and attach the center
speaker to the top of the TV.

NS-AP7800C
Double-sided
adhesive tape
Double-sided
adhesive tape
Rubber Base
Rubber Base
Fastener

TV or rack
TV set
Fastener

Attaching the rubber base
1. Decide the location where you want to place the speaker.
2. Affix the double-sided adhesive tape on the bottom of the speaker.
3. Attach the supplied rubber bases to the speaker bottom.

Peel off
the seal

Notes
 Do not place the speaker on top of the TV if the area is smaller than the bottom area of the speaker. The
speaker may fall and might cause personal injury.
 Do not place the speaker on top of the TV with an inclination.
 Do not touch the adhesive surface after peeling off the seal as this will weaken its adhesive strength.
 Thoroughly wipe clean the surface where the fastener is to be applied. Note that adhesive strength is
weakened if the surface is dirty, oily or wet and that this may cause the center speaker to drop.
 Though this speaker is a magnetically shielded type, there may be some influence on a TV picture depending
on the type of TV or the placement of the speaker. In such a case, place the speaker apart from TV so that
there is no influence on TV picture.

WARNING


To avoid accidents resulting from tripping over loose speaker cords, they should be affixed to the wall or floor
molding.



Secure installation is the purchaser's responsibility.

5

NS-AP7800M/NS-AP7800E

CONNECTIONS TO THE RECEIVER
CONNECTIONS





Check to make sure that the power has been turned off before making connections.
Connect the (+) terminal of the amplifier to the (+) terminal of the speaker.
Connect the (–) terminal of the amplifier to the (–) terminal of the speaker.
Reversing polarity (+/–) will result in unnatural sound reproduction.

Note
Do not let the bare speaker wires touch each other as this could damage the speaker, the amplifier, or both.

PROCEDURE
For connections, keep the speaker cords as short as possible. Do not bundle or roll up the excess part of the
cords. If the connections are faulty, no sound will be heard from the speakers. Make sure that the + and – polarity
markings of the speaker cords are observed and set correctly. If these cords are reversed, the sound will be
unnatural and lack bass.

How to Connect:
1 Press and hold the terminal’s tab.
2 Insert the bare wire into the terminal hole.
[Remove approx. 10 mm (3/8”) insulation from the speaker cords.]

Good

No Good

10 mm

Make sure the lead portions of
the speaker cable are not
exposed outside of the
connectors.

3 Release your finger from the tab to allow it to lock securely on the bare wire end.
4 Test the firmness of the connection by pulling lightly on the cord at the terminal.

6

NS-AP7800M/NS-AP7800E

SPEAKER PLACEMENT
This speaker system consists of front, center and surround speakers.
— Front speaker placement should be separated by a distance of 6–10ft. If they are placed too close together,
there will be a reduction in the stereo effect. Conversely, If placed too far apart, the so called “middleomission” effect will occur and the vocal center fill will be lost. Height of the speaker should be at least at ear
level.
— Center channel speakers should be placed centered above or below the TV.
— Surround speakers should ideally be placed behind the listening area, at least as far apart as the front
speakers and up to 2 additional feet apart per side. The height of the speaker should be at a minimum of ear
level or preferably somewhat higher.

Center Speaker
Left Front Speaker

Right Front Speaker

6–10 feet

LISTENING AREA
up to approx
2 feet more

up to approx
2 feet more

Left Surround Speaker

Right Surround Speaker

7

NS-AP7800M/NS-AP7800E

SPECIFICATIONS
Type

2-Way Bass Reflex (Front)
2-Way Acoustic Suspension (Center, Surround)

Speaker

2-1/4" woofer x 2 + 3/4" silk dome tweeter

Frequency Range
Front
Center/Surround

90 Hz – 35 kHz
100 Hz – 35 kHz

Impedance

6 ohms

Nominal Input

30 W

Maximum Input

100 W

Sensitivity
Front
Center
Surround

82 dB/2.83 V/m
82 dB/2.83 V/m
82 dB/2.83 V/m

Crossover Frequency
Front
Center
Surround

4 kHz
4 kHz
4 kHz

Dimension (H x W x D)
Front (Cabinet)
(with Pedestal)
Center
Surround

40" x 3-11/16" x 4-3/4" (1016 x 93.5 x 120.5 mm)
41-3/16" x 3-11/16" x 4-3/4" (1046 x 93.5 x120.5 mm)
3-11/16" x 10" x 4-3/4" (93.5 x 254 x 120.5 mm)
10" x 3-11/16" x 4-3/4" (254 x 93.5 x 120.5 mm)

Weight
Front (with Pedestal)
(without Pedestal)
Center
Surround
Magnetic Shielding

4.42 kg/9.75 lbs
3.52 kg/7.76 lbs
1.55 kg/3.42 lbs
1.60 kg/3.53 lbs
Yes.

*Specifications subject to change without notice due to product improvements.

YAMAHA ELECTRONICS CORPORATION, USA
6660 ORANGETHORPE AVE.,
BUENA PARK, CA 90620
http://www.yamaha.com/yec
Phone: 1-800-492-6242

P/N 430063

NS-AP7800M/NS-AP7800E

Printed in China



Source Exif Data:
File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.6
Linearized                      : Yes
Encryption                      : Standard V2.3 (128-bit)
User Access                     : Print
Page Mode                       : UseThumbs
XMP Toolkit                     : 3.1-702
About                           : uuid:5ef1d03c-ba71-419d-a81f-df37c5cade63
Producer                        : Acrobat Distiller 6.0 (Windows)
Create Date                     : 2007:03:20 14:57:19+09:00
Modify Date                     : 2007:04:09 15:29:25-07:00
Metadata Date                   : 2007:04:09 15:29:25-07:00
Document ID                     : uuid:c7ad4a90-323c-4472-97db-73d5b1586c3c
Instance ID                     : uuid:c5c8ca82-3cd9-4b74-815b-f98bb1112574
Format                          : application/pdf
Title                           : untitled
Page Count                      : 8
EXIF Metadata provided by EXIF.tools

Navigation menu