Yinrun Industry 100121610 Tornado tumber User Manual 10012

Guangdong Yinrun Industry Co., LTD. Tornado tumber 10012

User Manual

Operating Instructions Battery Information The operation requires 6 “AA” 1.5V alkaline batteries for car and one 9V battery for remote control. z Carefully remove items from package. z Locate the battery compartment on the back of each item. z Unscrew latch on bottom of car to release battery pack and replace batteries following the correct polarities. z Replace open the battery compartment door of the controller. z Insert the 9V battery following the correct polarities. z Replace the battery compartment door. Safety Precautions z Do not operate during thunderstorms or rain. z Avoid water, sand and snow when operating your car. z Do not submerge car or controller in water. z Never operate your car on the street or highway. z Adult supervision is recommended when operating this car. z Remove all batteries when not in use to avoid accident operation. z Never operate your car in a confined or crowed area and do not use people or animals as obstacles. z Do not run your car into furniture, objects or hard surfaces, as this will cause damage to both the objects and the car. z Keep fingers, hair and loose clothing away from the tires, gears and motor while the car is switched to “ON”. z Do not leave car or transmitter near sources of heat or under direct sunlight for long periods of time. z Do not leave car or transmitter outside overnight. Dampness is harmful to interior components. Battery Warning z Do not mix old and new batteries. z Do not mix alkaline, standard(carbon-zinc) or rechargeable(nickel-cadmium) batteries. z Insert batteries using the correct polarity. Do not short-circuit the supply terminal. z Remove batteries when not in use. Recycle or dispose of exhausted batteries according to federal. State or local laws. Do not dispose of batteries in a fire- they make leak or explode.
z Only use manufacture specified battery(ies), charger(s) and/or adapter, if applicable, specifies by the manufacturer. z Always use, replace and recharge (if applicable) batteries under adult supervision. z Non-rechargeable batteries are not to be recharged. FCC Compliance Statement: This device complies with Part 15 of the FCC rules. Operation is subjected to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. IC Compliance Statement: This device complies with Industry Canada’s licence-exempt RSSs.Operation is subject to the following two conditions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operation of the device. Cet appareil est conforme aux CNR exemptes de licence d'Industrie Canada . Son fonctionnement est soumis aux deux conditions suivantes : ( 1 ) Ce dispositif ne peut causer d'interférences ; et ( 2 ) Ce dispositif doit accepter toute interférence , y compris les interférences qui peuvent causer un mauvais fonctionnement de l'appareil. Changes or modifications not expressly approved by the party responsible for compliance could void your authority to operate the equipment. Keep This Package For Reference As It Contains Important Information. Left joystick Right joystickForward Reverse Uses 1pc 9V battery ON/OFF Switch Installing the antenna
 Press single joystick backward: spin with the side wheels revolve up and down Press the sticks in opposite direction: full spin Press both joysticks forward: forward Press both joysticks backward: backward with both side wheels revolve up and down Performing stunts Press single joystick forward: forward Press the sticks in opposite direction: full spin

Navigation menu