Youngshin Electronics J2000R Transceiver of Car Alarm/Remote Engine Starter User Manual

Youngshin Electronics Co., LTD. Transceiver of Car Alarm/Remote Engine Starter Users Manual

Users Manual

Page 1 of 8 - 1 -CompuStar 2000ASUSER’S GUIDEFirstech, Inc. 801 E. 82nd Ave Suite 1 Anchorage AK. 99518 (907) 563-8648This device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference,and (2) this device must accept any interferencereceived, including interference that may causeundesired operation.CAUTION: Changes or modifications not expressly approved by the partyresponsible for compliance could void the user’s authority to operate this device.This equipment has been tested and found to comply with the limits for a ClassB digital device, pursuant to Part 15 of the FCC Rules. These limits aredesigned to provide reasonable protection against harmful interference in aresidential installation. This equipment generates, uses and can radiate radiofrequency energy and, if not installed and used in accordance with theinstructions, may cause harmful interference to radio communications.However, there is no guarantee that interference will not occur in a particularinstallation. If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning the equipment off andon, the user is encouraged to try to correct the interference by one or more ofthe following measures:• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different from that towhich the receiver is connected.• Consult the dealer or an experienced radio/TV technician for help.
Page 2 of 8 - 2 -INTRODUCTIONThank you for choosing COMPUSTAR, a state-of-the-art TWO WAYalarm/remote start systems for your vehicle. We, at FIRSTECH, INC., areconstantly researching and developing to make you and your vehicle safe andmore comfortable. SECURITY & COMFORT, that’s what FIRSTECH, INC. is allabout.TABLE OF CONTENTS1. Transmitter Button functions ---------------------------------------------------Page 32. Alarm Function------------------------------------------------------------------------Page 33. Panic-------------------------------------------------------------------------------------Page 34. Start Function--------------------------------------------------------------------------Page 35. Safety Shutdown----------------------------------------------------------------------Page 46. VPS(Vehicle Paging System)------------------------------------------------------Page 47. Aux 1 and Aux 2-----------------------------------------------------------------------Page 48. Valet Mode and Valet Switch------------------------------------------------------Page 49. Shock Sensor--------------------------------------------------------------------------Page 410. Timer Start-----------------------------------------------------------------------------Page 411. 2nd Car----------------------------------------------------------------------------------Page 412. Transmitter Learning Procedure-------------------------------------------------Page 413. Programming Options with Transmitter----------------------------------------Page 514. Warranty Statement-----------------------------------------------------------------Page 715. Registration Card---------------------------------------------------------------------Page 8
Page 3 of 8 - 3 -1. Transmitter Button FunctionsChannel Button Pressfor Function FactorySetting1. I 1/2 sec Arm/Disarm; VPS on/off2. II 1/2 sec Aux 13. III 1/2 sec Aux 24. IV 1/2 sec Query5. I - 2 sec Panic6. II - 2 sec Remote Starting - On/Off7. III- 2 sec Trunk8. IV- 2 sec CompuGlo Back Light On/Off On9. (I+II) 1/2 sec Siren Chip - On/Off On10. (I+III) 1/2 sec Valet Mode - On/Off Off11. (I+IV) 1/2 sec Shock Sensor On/Off On12. (II+III) 1/2 sec Transmitter Beep - On/Off On13. (II+IV) 1/2 sec Timer Mode 1.5 hour - On/Off Off14. (III+IV) 1/2 sec 2nd Car Off15. (I+II)- 2 sec Option Programming 116. (I+III)- 2 sec Option Programming 22. Alarm FunctionUpon arming, your alarm will be triggered by:• Light Impact (first stage shock sensor). The siren will chirp 4 times and the parkinglights will flash for a few seconds. The transmitter will be paged and the vibrationicon will appear in the LCD.• Heavy impacts (second stage shock sensor). The siren will go off and the parkinglights flash for 60 Seconds. The transmitter will be paged and the Hammer in theLCD will appear.• Door opened. The siren will go off and the parking lights will flash for 60 Seconds.The transmitter will be paged and the door icon will appear in the LCD.• If you have installed the Optional starter kill function, your vehicle will not start withkey when system is armed.Note: (Siren duration 30Sec. or 60Sec. refer to programming section)3. PanicIn Case of an emergence and you want to track attention. Press Button I for 2 Secondsand you will enter Panic Mode. The siren will go off and the parking light will startflashing. To disengage Panic Mode. Press Button I for ½ Second.
Page 4 of 8 - 4 -4. Start FunctionPress Button II for 2 Seconds to start the engine. The engine will start and give you aconfirmation on the Remote-pager. The engine will run 15 minutes (25 min for diesel) or25 minutes (40 min for diesel) . If the engine has a problem starting the system will retry2 more times. If the engine dose not start after the 3rd attempt, please call youAuthorized Dealer.Note: Runtime, please consult you Authorized Dealer.5. Safety Shut DownSystem has several Shut Down inputs. That will shut down the engine or prevent fromremote starting.• the Hood is opened,• the Brake is pressed,• the Valet is entered, or• the Valet switch is turned on.6. VPS(Vehicle Paging System)VPS is turned on upon arming. If the VPS sensor is triggered by an impact such asknocking on the VPS module, the transmitter will be paged.7. Aux 1 & Aux 2The system has Aux 1 & Aux 2 output to be utilized with optional features. (Consult yourAuthorized Dealer)8. Valet Mode and Valet SwitchTo enter Valet mode, press Buttons I & III simultaneously for ½ Second or insert the keyinto the ignition and tuned the ignition on and off five times within 10 seconds. In Valetmode, the system will only activate Locks, Trunk, and the Auxiliary only. To exit ValetMode press Button I & III simultaneously for ½ Second.9. Shock SensorDual Stage Shock Sensor will activate 30 Sec. after the system is Armed (Locked).When 1st stage is triggered the siren will chirp 4 times and Remote-pager will receive anotification of the violation.(Vibration Icon will appear) When 2nd stage is triggered thesiren will activate and Remote-pager will receive a notification of the violation.(Hammerwill appear)10. Timer ModeTo enter the Timer Mode press Buttons II & IV simultaneously for ½ Second. Thesystem will start every 1.5 Hrs. till Timer Mode is deactivated and automatically canceledif the vehicle is started with the Key or Remotely. To Exit Timer Mode press Button II &IV simultaneously for ½ Second again.11. 2nd Car ModeSystem is able to operate 2nd vehicle. Press Buttons III & IV simultaneously for ½Second. Feature may be different for 2nd vehicle regards to options. To Exit 2nd Carpress Button III & IV simultaneously again. (Consult your Authorized Dealer)
Page 5 of 8 - 5 -12. Transmitter Learning ProcedureYour transmitter has been programmed at the factory. However, if you replace or addadditional Remote-pager, follow this procedure.Steps 1: Put the system in Valet mode with key: Ignition On and Off Five times with keywithin 10 seconds. The parking light will flash once.Step 2: Within 6 seconds, press any button for a half-second.Step3:The parking light will flash twice to confirm Step 2.Step 4: Program 2nd transmitter or 3rd transmitter by pressing any button. The systemwill program up to 3 transmitters. The parking light will flash once to confirm Step 3.13. Programming Options with TransmitterEach unit comes with factory setting. If you want to change any of those settings, followthis procedure.Step one: Press Buttons I+II simultaneously for 2 seconds to change any of the Option#1 options or Press Buttons I+III simultaneously for 2 seconds to change any of theOption #2 options. Confirmed by chirp and parking light - one time.Step two: Within 2 seconds press Button IV for the same number of time as the optionnumber you wish to change. Confirmed by chirp and parking light - same number oftime of the option number.Step three: Press Button I a ½ second to change to the factory setting - confirmed bychirp and parking light by one time. Press Button II a ½ second to change to the optionsetting - confirmed by chirp and parking light by two times. If you hear one second chirp,it means the unit did not receive any signal in this step – repeat Step one again.Option #1: Option Programming (Press I and II simultaneously for 2 seconds)No Options Factory Setting Option Setting1. Factory Arm/Disarm/Rearm with TransmitterCopier No Yes2. The duration of Lock/Unlock pulse 0.5 sec 2.5 sec3. Extended Cranking Time by .2 sec No Yes4. Safety Unlock (Lock/Unlock/Unlock) No Yes5. Double Pulse Unlock No Yes6. Passive Arming No Yes7. Passive Locking No Yes8. Disarm with Trunk Unlock Yes No9. Duration of the Siren Output 60 sec 30 sec10. Factory Rearm with Dome-light No Yes
Page 6 of 8 - 6 -Option #2: Option Programming (Press I and III simultaneously for 2 seconds)No Options Factory Setting Option Setting1. Harness #1, #5 Wire Ignition 2nd Starter2. Aux 1 Output .5 sec See Note 13. Aux 2 Output .5 sec See Note 24. Ignition Lock No Yes5. Siren Activation DeactivationNote 1: Aux 1 continues output until Button II is pressed for 1/2 sec. again or Key Onwhichever comes first.Note 2: Aux 2 continues output until Button III is pressed for 1/2 sec. again or Key Onwhichever comes first.14. Option Resetting: To Reset to the factory default settings.Step 1: Press Buttons I+II simultaneously or I+III simultaneously for 2 seconds.Confirmed by chirp and parking light - one time.Step 2: Press Button III three times. Confirmed by chirps and parking lights - threetimes.
Page 7 of 8 - 7 -15. Limited Lifetime WarrantyFirstech, Inc. Warrants to the original purchaser that this product shall be free of defectsin material and workmanship under normal use and circumstances for the period of timethat the original owner of this product owns the vehicle in which it is installed; except thatthe remote controller unit for the period of one year from the date of installation to theoriginal owner of this product. When the original purchaser returns the product to theretail store where it was purchased or pre-paid postal to Firstech, Inc., 230 E. PotterSuite 8, Anchorage, Alaska 99518, USA within the warranty period, and if the product isdefective Firstech, Inc, will at its option repair or replace such.“TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALL WARRANTIES AREEXCLUDED BY THE MANUFACTURER AND EACH ENTITY PARTICIPATING IN THESTREAM OF COMMERCE THEREWITH. THIS EXCLUSION INCLUDES BUT IS NOTLIMITED TO, THE EXCLUSION OF ANY AND ALL WARRANTY OFMERCHANTABILITY AND/OR ANY AND ALL WARRANTY OF FITNESS FOR APARTICULAR PURPOSE AND/OR AHY AND ALL WARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THE UNITED STATES OF ANERICA AND/OFABROAD. NEITHER THE MANUFACTURER OR ANY ENTITIES CONNECTEDTHEREWITH SHALL BE RESPONSIBLE OR LIABLE FOR ANY DAMAGESWHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANY CONSEQUENTIALDAMAGES, INCIDENTAL DAMAGES, DAMAGES FOR LOSS OF TIME, LOSS OFEARNINGS, COMMERCIAL LOSS, LOSS OF ECOMONIC OPPORTUNITY AND THELIKE. NOTHWITHSTANDING THE ABOVE, MANUFACTURER DOES OFFER ALIMITED WARRANTY TO REPLACE OR REPAIR THE CONTROL MODULE ASDESCRIBED ABOVE. Some states do not allow limitations on how long an impliedwarranty will last or the exclusion or limitation of incidental or consequential damages.This warranty gives you specific legal rights, and you may also have other rights, whichvary State to State.IMPORTANT NOTE:A product’s warranty is automatically void if its date code or serial number is defaced,missing, or altered. This warranty will not be valid unless you have completed thewarranty card and mailed it to Firstech, Inc., within 10 days after purchase to theaddress listed on the card.
Page 8 of 8 - 8 -16. Registration CardName__________________________________________________________Address________________________________________________________City__________________ State___________________ Zip____________Phone Number: Home ( )_____________ Office ( )______________Place of Purchase__________________________ Date of Purchase______Purchase Model___________________ Purchase Price__________Vehicle Make___________________ Model:_________________________How did you hear about this product?_______________________________Firstech Inc.801 E. 82nd Ave. Suite 1Anchorage, AK 99518

Navigation menu