Youngshin Electronics JA311R Car Alarm User Manual users manual

Youngshin Electronics Co., LTD. Car Alarm users manual

users manual

CompuStar 2000-AS User's Manual Page 1 of 10FCC ID : O44JA311R CompuStar A311RUSER’S GUIDEThis device complies with Part 15 of the FCC Rules.Operation is subject to the following two conditions:(1) This device may not cause harmful interference,and (2) this device must accept any interferencereceived, including interference that may causeundesired operation.CAUTION: Changes or modifications not expressly approved bythe party responsible for compliance could void the user’s authorityto operate this device.This equipment has been tested and found to comply with the limitsfor a Class B digital device, pursuant to Part 15 of the FCC Rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipmentgenerates, uses and can radiate radio frequency energy and, if notinstalled and used in accordance with the instructions, may causeharmful interference to radio communications. However, there is noguarantee that interference will not occur in a particular installation.If this equipment does cause harmful interference to radio ortelevision reception, which can be determined by turning theequipment off and on, the user is encouraged to try to correct theinterference by one or more of the following measures:
CompuStar 2000-AS User's Manual Page 2 of 10• Reorient or relocate the receiving antenna.• Increase the separation between the equipment and receiver.• Connect the equipment into an outlet on a circuit different fromthat to which the receiver is connected.• Consult your Authorized CompuStar dealer.1. Transmitter Button FunctionsChannel Button Function1. Lock Arm2. Unlock Disarm3. Lock+Panic Aux 14. Unlock+Panic Aux 25. Panic Panic6. Start Remote Starting7. Stop Remote Stop8. Trunk Trunk Release9. (Lock+Unlock) Siren Chip - On/Off10. (Lock+Start) Valet Mode - On/Off11. (Lock+Stop) Shock Sensor On/Off13. (Unlock+Stop) Timer Mode 1.5 hour -On/Off15. (Lock+Trunk) Option Programming 116. (Unlock+Trunk) Option Programming 2
CompuStar 2000-AS User's Manual Page 3 of 102. Alarm FunctionUpon arming, your alarm will be triggered by:• Light Impact (first stage shock sensor). The siren will chirp 4times and the parking lights will flash 4 times.• Heavy impacts (second stage shock sensor). The siren will go offand the parking lights will flash for 60 seconds.• Door opened. The siren will go off and the parking lights will flashfor 60 seconds• If you have installed the Optional starter kill function, your vehicle willnot start with key when system is armed.Note: (Siren duration 30Sec. or 60Sec. refer to programming section)3. PanicIn Case of emergency, and you want to attract attention. Press buttonPanic.4. Start FunctionPress button III for 2 seconds to start the engine. The engine will start.The engine will run 15 minutes (25 min for diesel) or 25 minutes (40 minfor diesel). If the engine has a problem starting the system will retry 2additional times. If the engine does not start after the 3rd attempt, please callyou Authorized Dealer.Note: Runtime, please consult you Authorized Dealer.Diagnosis for Remote Starting ErrorIf there is an error, you will hear three chirps when you attempt to remotestarting the vehicle. 2 seconds later, the cause for the error will be indicatedby the chirping and parking light flashes.ErrorNumber Error Reason1Engine On2Key On3 Door Open4 Trunk Open5 Brake On / Valet Switch On6 Hood Open
CompuStar 2000-AS User's Manual Page 4 of 107 Reservation Off (Manual Transmission Only)5. Remote Starting for the manual transmissionIMPORTANT1. The transmission must be in the NEUTRAL position.2. The vehicle windows must be rolled up.3. Do not set the reservation mode with any people in thevehicle.4. Do not remote start with any people in the vehicle.Note: The system is not recommended for vehicle withremovable tops.Reservation Mode must be set for manual transmission.Step 1: After arriving at the destination, and before turning theengine OFF, place the transmission in the Neutral position.Step 2: Remove your foot from the foot brake.Step 3: Activate the parking brake.Step 4. Remove the key from the ignition. The engine will remainrunning.Step 5. Exit the vehicle and close the door within two minutes fromstep 3. The engine will shut off and reservation mode for theremote starter is now complete.Your vehicle is now ready for remote starting. However, thereservation mode will be cancelled if the door is opened or theCompuStar is put in Valet mode after the reservation has been set.Once cancelled, you will have to start the vehicle with the key andrepeat the above 5 steps if you want to restore the reservation.Note: If you try to remote start the vehicle when the reservationmode has not been set or cancelled, the system will not start. Theparking lights will flash three timesCanceling Reservation Mode
CompuStar 2000-AS User's Manual Page 5 of 10If you do not want to set the reservation mode, shut off the enginebefore you exit the vehicle. The engine will shut off if (a) you donot activate your parking brake or press the foot brake when youturn your key to off position, (b) release your parking brake whileengine is running, or if (c) you press button III between step 3 and4.6. Safety Shut DownSystem has several Shut Down inputs. That will shut down the engine orprevent from remote starting.• the Hood is opened,• the Brake is pressed,• the Valet mode is entered, or• the Valet switch is turned on.7. Aux 1 & Aux 2The system has Aux 1 & Aux 2 output to be utilized with optional features.(Consult your Authorized Dealer)8. Valet Mode In Valet mode, the system will only activate Locks, Trunk, and theAuxiliary only9. Valet SwitchTurn On the switch to shut off the Remote Starter System only. Turn OffBy-Pass switch to activate remote starting function.10. Shock SensorDual Stage Shock Sensor will activate 30 sec. After the system is armed(Locked). When 1st stage is triggered the siren will chirp 4 .11. Timer StartTo enter the Timer Mode press buttons Unlock & Stop simultaneously for½ second. The system will start every 1.5 Hrs. till Timer Mode isdeactivated and automatically canceled if the vehicle is started with the Key
CompuStar 2000-AS User's Manual Page 6 of 10or Remotely. To Exit Timer Mode press buttons Unlock & Stopsimultaneously for ½ second again.12. Transmitter Learning ProcedureYour transmitter has been programmed at the factory. However, ifyou replace or add additional Remote, follow this procedure.Steps 1: Put the system in Valet mode with key: Ignition on and offfive times with key within 10 seconds. The parking light will flashonce.Step 2: Within 6 seconds, press the button Lock for a half-second.Step3: The parking light will flash twice to confirm Step 2.Step 4: Program 2nd transmitter or 3rd transmitter by pressing anybutton. The system will program up to 3 transmitters. The parkinglight will flash once to confirm Step 3.13. Programming Options with TransmitterStep 1. Programming Option 1. Press buttons Lock and Unlock for 2seconds. Programming Option 2: Press buttons Lock and Start for 2seconds. The siren will chirp once. Now you are in the programmingmode.Step 2. Within 2 seconds, press Stop for the number of times to goto the option number you want to change. You will hear a chirp andsee the parking lights flash each time you press button Stop.Step 3. Wait few seconds. You will hear a number of chirps and seea number of parking light flashes corresponding the number of theoption you want to change. If the number of chirps or flashes is notwhat you wanted, go back to the Step 1.Step 4. Press Lock for the factory setting; one chirp and one flash.Press Unlock for the Option Setting; two chirps and two flashes.• If you hear a long chirp, you are going out of theprogramming mode. Go back to the step one.• If you want to change more options go back to the step I.
CompuStar 2000-AS User's Manual Page 7 of 10Option Resetting: No. Factory Setting -Button I Option Setting - Button II1No unlock before remotestarting Unlock before remote startingfor factory disarm.2.5 sec lock/unlock pulse 2.0 sec lock/unlock pulseMinimum Cranking Time for the Alternator Setting31st Try 2nd Try 3rd Try.8 sec .9 sec 1.0 sec1st Try 2nd Try 3rd Try1.0 sec 1.1 sec 1.2 sec4Regular Unlock Safety Unlock (Lock, Unlock,Unlock)5Regular Unlock Double Unlock6Regular Dome Light Dome Light Factory Rearm(Dome Light before Lock Pulse)Option 17Regular Remote StartActivation Input Cold start with TemperatureSensor. With this option, theminimum interval betweenautomatic starts will be 1.5hour.
CompuStar 2000-AS User's Manual Page 8 of 10No. Factory Setting - Button I Factory Setting - Button II1Active Arming (Locking) Passive Arming but ActiveLocking2Active Arming (Locking) Passive Arming and PassiveLocking3.5 sec Aux 1 Output Latch Aux 1 Output4.5 sec Aux 2 Output Latch Aux 2 Output5No Ignition Lock Ignition Lock630 sec Siren Duration 60 sec Siren DurationOption 27Arming (Locking) uponreservation No Arming (Locking) uponreservationTo Reset Everything to the factory default settings.Step 1: Press buttons Lock+Unlock simultaneously or Lock+Startsimultaneously for 2 seconds. Confirmed by chirp and parking light -one time.Step 2: Press button Start three times. Confirmed by a chirp andparking light each time you press button Start and three chirps andflash after your press button Start three times.
CompuStar 2000-AS User's Manual Page 9 of 1014. Limited Lifetime WarrantyFirstech, Inc. Warrants to the original purchaser that this productshall be free of defects in material and workmanship under normaluse and circumstances for the period of time that the original ownerof this product owns the vehicle in which it is installed; except thatthe remote controller unit for the period of one year from the date ofinstallation to the original owner of this product. When the originalpurchaser returns the product to the retail store where it waspurchased or pre-paid postal to Firstech, Inc., 801 E. 82nd Ave. Suite1, Anchorage, Alaska 99518, USA within the warranty period, and ifthe product is defective Firstech, Inc, will at its option repair orreplace such.“TO THE MAXIMUM EXTENT ALLOWED BY LAW, ANY AND ALLWARRANTIES ARE EXCLUDED BY THE MANUFACTURER ANDEACH ENTITY PARTICIPATING IN THE STREAM OF COMMERCETHEREWITH. THIS EXCLUSION INCLUDES BUT IS NOT LIMITEDTO, THE EXCLUSION OF ANY AND ALL WARRANTY OFMERCHANTABILITY AND/OR ANY AND ALL WARRANTY OFFITNESS FOR A PARTICULAR PURPOSE AND/OR AHY AND ALLWARRANTY OF NON-INFRINGEMENT OF PATENTS, IN THEUNITED STATES OF ANERICA AND/OF ABROAD. NEITHER THEMANUFACTURER OR ANY ENTITIES CONNECTED THEREWITHSHALL BE RESPONSIBLE OR LIABLE FOR ANY DAMAGESWHATSOEVER, INCLUDING BUT NOT LIMITED TO, ANYCONSEQUENTIAL DAMAGES, INCIDENTAL DAMAGES,DAMAGES FOR LOSS OF TIME, LOSS OF EARNINGS,COMMERCIAL LOSS, LOSS OF ECOMONIC OPPORTUNITY ANDTHE LIKE. NOTHWITHSTANDING THE ABOVE, MANUFACTURERDOES OFFER A LIMITED WARRANTY TO REPLACE OR REPAIRTHE CONTROL MODULE AS DESCRIBED ABOVE. Some statesdo not allow limitations on how long an implied warranty will last orthe exclusion or limitation of incidental or consequential damages.This warranty gives you specific legal rights, and you may also haveother rights, which vary State to State.
CompuStar 2000-AS User's Manual Page 10 of 10IMPORTANT NOTE:A product’s warranty is automatically void if its date code orserial number is defaced, missing, or altered. This warrantywill not be valid unless you have completed the warranty cardand mailed it to Firstech, Inc., within 10 days after purchase tothe address listed on the card.Registration CardName______________________________________________________________________________________________Address____________________________________________________________________________________________City__________________ State___________________Zip____________Phone Number: Home ( )_____________ Office ( )___________Place of Purchase__________________________Date of Purchase______Purchase Model___________________Purchase Price__________Vehicle Make___________________Model:_________________________How did you hear about this product?_______________________ ____________________________________________________Firstech Inc.801 E. 82nd Ave. Suite 1 Anchorage, AK 99518

Navigation menu