Yuneec Technology MK58 Digital Video Downlink User Manual MINI LK58 0820

Yuneec Technology Co., Limited Digital Video Downlink MINI LK58 0820

MK58 User Manual 0820

4. POWERING ONStep 1) Plug the audio connector into audio port of the MK58; then plug the 4PIN power connector into power output port of GB203.IMPORTANT NOTE：In this User Manual, the TYPHOON is taken as an example. If you have any other compable power supply equipment or wearable equipment, you can plug the 4PIN power connector of the MK58 into power output port of other equipment as well.STEP 1. Plug the MINI USB connector into USB interface of GoPro CameraSTEP 2 . Switch on the GoPro Camera. Power on the MK58.IMPORTANT NOTE：In this User Manual, the TYPHOON is taken as an example. If you have any other compable power supply equipment or wearable equipment, you can plug the 4PIN power connector of the MK58 into power output port of other equipment as well.STEP 3. Bind the MK58 to the Personal Ground Staon/Remote Controller: Switch on the Personal USING YOUR MK58Model: Typhoon Welcome,Pilot 10:48:28 pm 10BindCamera SelectHardware MonitorMode SelectSTEP8. Input password "12345678" and then tap "OK". The binding succeeds.STEP 9. Aer the Ground Staon/ Controller and the MK58 are bound, the red LED of the MK58 will blink. Press to return to the main interface of the Ground Staon/Controller. The real-me images can be shown on the interface of the Ground Staon/ Controller.IMPORTANT NOTE: All safety precauons and warnings, instrucons, warranes and other collateral informaon is subject to change at the sole discreon of Yuneec. For the most up-to-date informaon please visit the corresponding product page at www.Yuneec.com or contact the nearest Yuneec office or authorized distributor.The following special language terms are used throughout the product literature to indicate various levels of potenal harm when operang this product: NOTICE: Procedures, which if not properly followed, create a possibility of property damage and/or lile to no possibility of injury. CAUTION: Procedures, which if not properly followed, create the probability of property damage and/or a possibility of serious injury. WARNING: Procedures, which if not properly followed, create the probability of property damage, collateral damage and/or serious injury or create a high probability of superficial injury. WARNING: Read the ENTIRE instrucon manual to become familiar with the features of the product before operang. Failure to operate the product correctly can result in damage to the product, property and/or cause serious injury.WARNING: This is a sophiscated consumer product. It must be operated with cauon and common sense, and requires some basic mechanical ability. Failure to operate this product in a safe and responsible manner could result in damage to the product, property and/or cause serious injury. This product is not intended for use by children without direct adult supervision. Do not use with incompable components or alter this product in any way outside of the instrucons provided by Yuneec. The instrucon manual contain instrucons for safety, operaon and maintenance. NOTICES AND WARNINGSFCC STATEMENT:This equipment has been tested and found to comply with the limits for Part 15 of the FCC rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio communicaons. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: 1. INTRODUCTIONThe MK58 is a professional digital video downlink module, especially designed for GoPro Camera Without any other extra module, real-me images can be directly transferred to the Ground Staon/ Controller with almost no delay. The MK58 is portable in size and allows for easy installaon. 6. CONTROLLING THE MK582. SPECIFICATIONSDimensions (without antenna):2.48 X 1.19 X 0.45 in (63 X 30.2 X 11.5 mm)Weight (With antenna, connector): 36 g (1.27 oz)Compable Camera : GoPro Hero 3, Hero 3+, Hero 4 Black Hero 4 SilverWorking Voltage: 5V（+/-0.5V）Working Current: 1AVideo Transmission Range: 400m3. LED STATUS:Upon Powering On: Blue LED solid.Aer Powering On: Red LED solid.Aer binding to Personal Ground Staon/Remote Controller: Red LED blinking.Controlling the MK58 by Personal Ground Staon/ Remote ControllerNOTICE: The inappropriate pasng posion may cause electronic interference or poor venlaon.It is essenal to read and follow all the instrucons and warnings prior to assembly, setup and/or use in order to operate the product correctly and avoid damage or serious injury. Age recommendaon: not for children under 14 years. This is not a toy. GENERAL SAFETY PRECAUTIONS AND WARNINGSWARNING: Failure to use this product in the intended manner as described in instrucon manual can result in damage to the product, property and/or cause serious injury. This product is not a toy! If misused it can cause serious bodily harm and damage to property. WARNING: As the user of this product you are solely and wholly responsible for operang it in a manner that does not endanger yourself and others or result in damage to the product or the property of others. Do not aempt to operate your equipment in areas with potenal magnec and/or radio interference including areas nearby broadcast towers, power transmission staons, high voltage power lines, etc.Reorient or relocate the receiving antenna. Increase the separaon between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected.This device complies with part 15 of the FCC rules. Operaon is subject to the following two condions:(1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operaon. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protecon against harmful interference in a residenal installaon. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instrucons, may cause harmful interference to radio communica-ons. However, there is no guarantee that interference will not occur in a parcular installaon. If this equipment does cause harmful interference to radio or television recepon, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:—Reorient or relocate the receiving antenna.—Increase the separaon between the equipment and receiver.—Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.—Consult the dealer or an experienced radio/TV technician for help.RF EXPOSURE WARNINGThis equipment must be installed and operated in accordance with provided instrucons and the antenna(s) used for this transmier must be installed to provide a separaon distance of at least 20 cm from all persons and must not be co-located or operang in conjuncon with any other antenna or transmier. End-users and installers must be provide with antenna installaon instrucons Ground Staon/Remote Controller and tap "Flight Seng".STEP 4. Select "Camera Select".USER MANUALSTEP 1. Plug the antenna in the antenna port.NOTICE: When plugging the antenna in and out of the antenna port, it should be in vercal posion (see illustraon above).STEP 2. Plug the powercord in the audio port.STEP 3. Remove the adhesive tape on the MK58.Do not bend the antenna!The text described in the User Manual takes TYPHOON Q500 series, GB203 and ST10+ from YUNEEC as example.You should read the User Manual completely before proceeding.Do not operate the MK58 in the rain!Do not expose the MK58 to fire sources!WARNING !Do not expose the MK58 to excessive heat or sun light!Do not fly in winds that exceed 17MPH (28KPH)!MINI USBMINI USBMK58 BodyPower CordMushroonAntenna4PIN T-F Card PortAudio Connector4PINAUDIOSTEP 4. Paste the MK58 within the red marked area.STEP 5. Select "GoPro", tap "Select" and then tap "OK". Then the Camera Mode is chosen. STEP 6. Back to the previous interface and tap “Bind”.STEP 7. Select the MK58 in "Camera" interface .Step 2) Switch on the aircra and the MK58 will be supplied with power. Then the blue LED of the MK58 is on.NOTICE: Aer about 30 seconds, the red LED of the MK58 is on, which indicates the MK58 is ready to work.5. POWERING OFFSwitch off the aircra and the MK58 powers off. The blue and red LED of the MK58 will be off.Model: Typhoon Welcome,Pilot 10:48:28 pm 10GPSReadySAT13POS00.0000E00.0000NMODEAngleALT21.4 VOLTS12.3 VG-SPD0.0 mphDIS22.5 System Sengs Flight Sengs Model SelectHOME20/08 MK58 USER MANUAL Any informaon above might be changed due to the soware update. For the latest documents, please check the official website.and transmier operang condions for sasfying RF exposure compliance.IC RADIATION EXPOSURE STATEMENT FOR CANADAThis device complies with Industry Canada licence-exempt RSS standard(s).Operaon is subject to the following two condions: (1) this device may not cause interference, and (2) this device must accept any interference, including interference that may cause undesired operaon of the device.Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de licence. L'exploitaon est autorisée aux deux condions suivantes : (1) l'appareil ne doit pas produire de brouillage, et (2) l'ulisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est suscepble d'en compromere le fonconnement.This equipment complies with IC RSS-102 radiaon exposure limit set forth for an uncontrolled environment.Cet équipement respecte les limites d'exposion aux rayonnements IC définies pour un environnement non contrôléThis radio transmier (11554B-MK58) has been approved by Industry Canada to operate with the antenna types listed below with the maximum permissible gain indicated. Antenna types not included in this list, having a gain greater than the maximum gain indicated for that type, are strictly prohibited for use with this device.Le présent émeeur radio (11554B-MK58) a été approuvé par Industrie Canada pour fonconner avec les types d'antenne énumérés ci-dessous et ayant un gain admissible maximal. Les types d'antenne non inclus dans cee liste, et dont le gain est supérieur au gain maximal indiqué, sont strictement interdits pour l'exploitaon de l'émeeur.

Navigation menu