Z Wave Aeotec Wallmote Quad User Manual

User Manual: Z-Wave Aeotec Z-Wave Wallmote Quad User Manual Aeotec_Z-Wave_Wallmote_Quad_User_Manual 285 docs

Open the PDF directly: View PDF .
Page Count: 7

12/28/2016 WallMoteQuad(UserGuide):AeotecbyAeonLabs

https://aeotec.freshdesk.com/support/solutions/articles/6000162392wallmotequaduserguide 1/7

WallMoteQuad(UserGuide)

Modifiedon:Wed,7Dec,2016at7:48PM

WallMote Quad.

AeotecWallMoteQuadisanintelligentZWaveremotecontrollerthatmountedonawall.Ithas4touchbuttonsthatyoucan

easilycontroltheZWavedevicesinyourhomenetworkviatouching,longpressingorslidingthebuttonareas.

ItssurfacehasaRGBLEDtoindicatethebuttonactionsalsoaccompaniedbytouchbeepandvibration.

TheWallMoteQuadisalsoasecurityZWavedeviceandsupportsOverTheAir(OTA)featurefortheproductsfirmware

upgrade.

Familiarize yourself with your WallMote Quad.

1.WallMoteQuad

2.BackMountplate

3.DoubleSidedtape

4.MicroUSBcable

12/28/2016 WallMoteQuad(UserGuide):AeotecbyAeonLabs

https://aeotec.freshdesk.com/support/solutions/articles/6000162392wallmotequaduserguide 2/7

Note:WhentheWallMoteisplacedonsomewhere,keeptheglassbuttonsurfaceupwarddirectionandnootherphysical

surfaceordesktopcontactwiththeglassbuttonsurfacetoavoidfalsetriggeringandbatteryconsumption.

Quick start.

Installing your WallMote Quad.

1.SelectingaplaceorwallinyourhometoaffixyourWallMoteQuad’sBackMountplate.

12/28/2016 WallMoteQuad(UserGuide):AeotecbyAeonLabs

https://aeotec.freshdesk.com/support/solutions/articles/6000162392wallmotequaduserguide 3/7

2.UsingtheDoublesidedtap,wipethetwosurfacescleanofanyoilordustwithadamptowel.Whenthesurfacehas

completelydried,peelonesideofthetapebackandattachittothecorrespondingsectionontherearsideoftheBack

MountingPlate.

Adding your WallMote Quad to your ZWave network.

WithyourmountingplatespreparedtoholdeachcomponentofyourWallMoteQuad,it’stimetoaddittoyourZWave

network.

1.LetyourZWaveprimarycontroller/gatewayenterintopairing/

2.inclusionmode.

3.TakeyourWallMoteQuadneartoyourprimarycontroller.PresstheActionButtononceonyourWallMoteQuad,theLED

willblinkwithgreencolor.

4.IfyourWallMoteQuadhasbeensuccessfullyaddedtoyourZWavenetwork,itsgreenLEDwillbesolidfor2seconds

andthenoff.IftheaddingwasunsuccessfulandtheredLEDwillbesolidfor2secondsandthenoff,repeattheabove

steps.

WithyourWallMoteQuadnowworkingasapartofyoursmarthome,you’llbeabletoconfigureitfromyourhomecontrol

softwareorphoneapplication.Pleaserefertoyoursoftware’suserguideforpreciseinstructionsonconfiguringtheWallMote

Quadtoyourneeds.

Attach your WallMote Quad to its Back Mounting plate.

WithyourWallMoteQuadaddedtotheZWavenetwork.It’snowtimetoinsertthemainunitintothecorrespondingBack

Mountplate.PutthemainunitinthetopleftdirectionontheBackMounting,andthenpushtheWallMoteQuadintotheBack

MountingPlate,theWallMoteQuadwillbeattractedbythemagnetsontheBackMountplate,asthefigurebelowshows.

12/28/2016 WallMoteQuad(UserGuide):AeotecbyAeonLabs

https://aeotec.freshdesk.com/support/solutions/articles/6000162392wallmotequaduserguide 4/7

Advanced Functions.

Send a wake up notification.

InordertosendyourWallMoteQuadnewconfigurationcommandsfromyourZWavecontrollerorgateway,itwillneedto

bewokenup.

RemoveyourWallMoteQuadunitfromitsBackMountingPlate,pressandholdtheActionButtonfor3seconds(thebuzzer

chirponceandtheorangeLEDwillbeON)onthebackoftheWallMoteQuadunitandthenreleaseit.Thiswilltriggerand

sendawakeupnotificationcommandtoyourcontroller/gateway,thenyourWallMoteQuadwillwakeupfor10minutesand

theorangeLEDwillfastblinkwhileitisawake(iftheWallMoteQuaddoesnotreceivetheWakeUpNoMore

InfofromtheprimaryController).

Removing your WallMote Quad from a ZWave network.

YourWallMoteQuadcanberemovedfromyourZWavenetworkatanytime.You'llneedtouseyourZWavenetwork'smain

controller/gateway.Todothis,pleaserefertothepartoftheirrespectivemanualsthattellyouhowtoremovedevicesfrom

yournetwork.

1.Putyourprimarycontrollerintodeviceremovalmode.

2.UnlockyourWallMoteQuadfromtheBackMountplateandtaketheWallMoteQuadunitneartoyourprimarycontroller.

3.PresstheActionButtononyourWallMoteQuad.

4.IfyourWallMoteQuadissuccessfullyremovedfromtheZWavenetwork,theLEDwillbecomeacolorfulgradientfora

fewsecondsandthenturnoff.Iftheremovingwasunsuccessful,theredLEDwillbesolidfor2secondsandthenturnoff,

repeattheabovesteps.

Security or Nonsecurity feature of your WallMote Quad in Zwave

network.

IncludingWallMoteQuadasanonsecuredevice:

IfyouwantyourWallMoteQuadasanonsecuritydeviceinyourZwavenetwork,youjustneedtopresstheActionButton

onceonWallMoteQuadwhenyouuseacontroller/gatewaytoadd/includeit.

12/28/2016 WallMoteQuad(UserGuide):AeotecbyAeonLabs

https://aeotec.freshdesk.com/support/solutions/articles/6000162392wallmotequaduserguide 5/7

ThegreenLEDwillbeonfor2secondsandthentheorangeLEDwillfastblinkfor10minutes(iftheWallMoteQuaddoes

notreceivetheWakeUpNoMoreInfocommandfromprimaryController)toindicatetheinclusionissuccessful.

IncludingWallMoteQuadasasecuredevice:

InordertotakefulladvantageofallfunctionalitytheWallMoteQuad,youmaywantyourWallMoteQuadisasecuritydevice

thatusessecure/encryptedmessagetocommunicateinZwavenetwork,soasecurityenabledcontroller/gatewayisneeded

fortheWallMoteQuadtobeusedasasecuritydevice.

YouneedtopresstheWallMoteQuad’sActionButton2timeswithin1secondwhenyoursecuritycontroller/gatewaystarts

thenetworkinclusion.

TheblueLEDwillbeonfor2secondsandthentheorangeLEDwillfastblinkfor10minutes(iftheWallMoteQuaddoesnot

receivetheWakeUpNo

MoreInfocommandfromprimaryController)toindicatetheinclusionissuccessful.

Advanced Parameter Configurations.

NotallgatewayswillallowyoutofurtherconfigureyourZWavedevices,butinthecasethatyourgatewaydoesallowit,

theWallMoteQuadhassomeavailableparameterconfigurationsthatwillallowyoutoconfigureitfurthertoyourliking.

Touchbeep

Thiswillenableordisablethesoundeffectswhenyoupressortouchthesensingarea.Bydefault,thisisenabled.

Parameter1[1byte]

0:Disable

1:Enable

Note:YoucanalsoenableordisablethesoundeffectsviapressingandholdingtheActionButtonfor12seconds(the

buzzerchirponceandtheredLEDwillfastblink)andthenrelease.

Touchvibration

Thiswillenableordisablethevibrationeffectswhenyoupressortouchthesensingarea.Bydefault,thisisenabled.

Parameter2[1byte]

0:Disable

1:Enable

Note:YoucanalsoenableordisablethevibrationeffectsviapressingandholdingtheActionButtonfor17seconds(the

buzzerchirponceandtheredLEDwillbesolid)andthenrelease.

Association table of the control buttons.

TheWallMoteQuadsupports9associationgroups,allcontrolbuttonscanactivatetheconfiguredscenesviasendingthe

CentralSceneNotificationstoprimarycontroller/gateway(Inassociationgroup1).InordertouseAssociationGroups,make

surethatyourgatewayorsoftwarecanallowyoutosetthese,inordertodoso,pleaserefertoyourgatewaysmanualon

settinggroupassociation.ThiswillallowtheWallMoteQuadtodirectlycommunicateON/OFForDimmingcommandsto

yourdeviceswithoutgoingthroughyourgateway.

12/28/2016 WallMoteQuad(UserGuide):AeotecbyAeonLabs

https://aeotec.freshdesk.com/support/solutions/articles/6000162392wallmotequaduserguide 6/7

Everycontrolbuttonalsocansendthecontrolcommandstocontrolthedevicesintheotherassociationgroups,seethe

tablebelow:

Dimmer control via sliding the button area.

TheWallMoteQuadalsosupportsslidingcontrol,whentheparameter4[1byte]hasbeensetto3,youcanslideupordown

onthebuttonareatocontroladimmerdevicebyslidingupordown.Swipinguponcewilldimupadimmerdevicebya

certainpercentage,whileswipingdownoncewilldimdownadimmerdevicebyacertainpercentage.

Your WallMote Quad’s battery.

YourWallMoteQuadhasainternalrechargeablelithiumbatterythatwillallowyoutochargeitwhenitisinlowbattery.The

charger’soutputshouldbeamicroUSBterminalwiththespecificationofoutputDC5V/1A.WhentheWallMoteQuadisin

chargestate,theorangeLEDwillbeon.IftheorangeLEDisoffandthegreenLEDremainson,thenitindicatesthatthe

batterychargeiscomplete.

Note:WhentheWallMoteisinlowbattery,youwillseetheorangeLEDwillblinkwhenyoutouchthecontrolbuttons.

Otherwise,iftheblueLEDblinkswhentouchingthebuttons,whichmeansthebatteryisinnormallevel.

Resetting your WallMote Quad.

12/28/2016 WallMoteQuad(UserGuide):AeotecbyAeonLabs

https://aeotec.freshdesk.com/support/solutions/articles/6000162392wallmotequaduserguide 7/7

Ifatsomestage,yourprimarycontrollerismissingorinoperable,youmaywishtofactoryresetyourWallMoteQuad’swhich

willremoveitfromitsnetworkthatitispairedto,andresetallconfiguredsettingsbacktodefault.Todothis,followthe

stepsbelow:

1.PressandholdtheActionbutton(20seconds).

2.TheLEDshouldblinkbetweengreen,purple,thenredwhichwillflashrapidlyuntilagreenLEDbecomessolidfor2

secondstoindicateasuccessfulfactoryreset.

3.LetgooftheActionButton.

Technical Specifications

Modelnumber:ZW130.

Powersupply:Rechargeablelithiumbattery,3.7V,640mAh.

Batterychargerinput:MicroUSBport,DC5V±0.5V,max1A.

Operatingtemperature:0°Cto40°C.

Relativehumidity:8%to80%.

Operatingdistance:Upto394feet/120metresoutdoors.

KnownUsesforvariousGateways

1.SmartthingsHub(https://aeotec.freshdesk.com/solution/articles/6000162573wallmotequadsmartthingshubcustom

devicehandlerbyerocm123)(CustomDeviceHandlerbyErocm123)

2.VeraUI7GroupAssociation(Articlecomingsoon)