Z and Z ELECTRONIC TECHNOLOGY BT-03 Bluetooth Earphone User Manual Manual

Z&Z; ELECTRONIC TECHNOLOGY Bluetooth Earphone Manual

Manual

Mobile Power user manual BT-03 Bluetooth headset function specification Product specification： The bluetooth specification：2.0+EDR 一：Charging instructions Charging instructions when the light is red Fully charged when the red light, bright blue light 二：Switch machine (button function: switch machine, answer, disconnect, resisted）： Long press Boot button for about 5 seconds, until the red and blue flashing, enter into the state of pairing. Long press Button for about 5 seconds to turn it off. 三：Bluetooth headset and phone connection： 1. Long press Boot button for about 5 seconds, until the red and blue flashing, enter into the state of pairing. 1. Open the phone bluetooth search for bluetooth devices。 2. When the mobile phone search to BT - 03 equipment, selected the headphones.
3. If the match is not successful, repeated operation, only need to match at a time. If the pairing is successful, the headset will flash blue lights, at this time to enter standby mode, you can press dial/answered the phone 四：Answering the phone: Click on the headset Button realize answer function. 五：Hang up the phone: Press on the phone hang up or press on the headset The key end call 六：Refuse to answer： 1. According to the phone Hang up the key 2. When the phone rang up and continue to hold on the headset The button about 1 second, realize hang up function. 七：call： 1． Use a mobile phone keyboard input dial number, and then click The key, the call is automatically transferred to the headset. Mobile power supply part of the electrical parameters 1. Charging input DC5V 1.5A 2. The output DC5V 2.1A 3. Insert the bluetooth headset charging automatically and display power FCC Caution: Any changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. This device and its antenna(s) must not be co-located or operating in conjunction with any
other antenna or transmitter. NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: -- Reorient or relocate the receiving antenna. -- Increase the separation between the equipment and receiver. -- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. -- Consult the dealer or an experienced radio/TV technician for help.

Navigation menu