ZHEJIANG JIECANG LINEAR MOTION TECHNOLOGY JCHR35H1 Remote Control User Manual JCHR35H1 Remote control

Users Manual

JCHR35H1 Remote control User manual

一、

Remote control

Effect Picture

二、 Remote control function description

2.1、 Code function:

A、Press the flashlight button，enter into code state；Bounce

button,exit the code state。

B、the code is ok，the indicator slow flash（2Hz) 2 times。

2.2、Keyboard：Press the corresponding key to output corresponding

key value, the key always press the signal output, release the key,

the signal stops output.The corresponding key values are shown

below:

Please note that changes or modifications not expressly

approved by the party responsible for compliance could void the

user’s authority to operate the equipment.

Note: This equipment has been tested and found to comply with

the limits for a Class B digital device, pursuant to part 15 of the FCC

Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This

equipment generates, uses and can radiate radio frequency energy

and, if not installed and used in accordance with the instructions,

may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular

installation. If this equipment does cause harmful interference to

radio or television reception, which can be determined by turning

the equipment off and on, the user is encouraged to try to correct

the interference by one or more of the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from

that to which the receiver is connected.

—Consult the dealer or an experienced radio/TV technician for

help.