ZHUHAI WINGPOW EROTIC and NOVELTY TOB1011 CLUB VIBE User Manual
ZHUHAI WINGPOW EROTIC & NOVELTY MANUFACTURING CO., LTD. CLUB VIBE Users Manual
Users Manual
Transmitter design scheme
Transmitter
Antenna
Ambient control
sensitive light Manual mode
Ambient control
mode
On/off
switch
MIC
Logic Block Diagram
Transmitter
antenna
High frequency local
oscillator signal modulate
Voltage-stabilizing and filter
Status
direction
Radio-frequency carrier
shift signal output
Spansion
signal processing unit
A/D coded conversion
output
Function
button circuit
12V battery
Coded
signal
433.92MHZ
quartz crystal
local oscillator
Sound control
chip
Microphone
Filter enlarge
Principle of operation
• This product use 433.92MHZ high-frequency RF technology scheme.
The electrocircuit include transmit antenna, self-oscillating, MCU,
button circuit, Status direction, audio-frequency signal enlarge
commutate and Voltage-stabilizing circuit.
• Main control chip via button scan identify to make the instruction in digital
analysis process. Or collect the analog signals by MIC to enlarge through
filtering. Then input to audio-frequency chip, couple and enlarge by
capacitance and commutate by diode to transfer the analog signals to digital
signals by internal A/D. Output to corresponding coded signal after
operation.
Coded signal will be mixing to load to high frequency INM-LO. Through
transmitting loop to send to ambient environment by antenna. So as to
control the receiving action.
Electrical Specification
• Supply voltage: 23A battery 12VDC
• Transmit range: main wave +17DB
second harmonic -18DB
• Transmit frequency: 433.92MHZ （+/-20PPM）
• Modulation type: AM
• FCC Statement
• 1. This device complies with Part 15 of the FCC Rules. Operation is subject to the following
• two conditions:
• (1) This device may not cause harmful interference, and
• (2) This device must accept any interference received, including interference that may
• cause undesired operation.
• 2. Changes or modifications not expressly approved by the party responsible for compliance
• could void the user’s authority to operate the equipment.
•Federal Communications Commission (FCC) Statement
• This equipment has been tested. And it found to comply with the limits for a Class B digital device pursuant to Part
15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates and uses and radiates radio frequency energy and, if not
installed and used in accordance with the instruction, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following measures:
• - Reorient or relocate the receiving antenna.
• - Increase the separation between the equipment and receiver.
• - Connect the equipment into an outlet on a circuit different from that to which the receiver is connected
• - Consult the dealer or an experienced radio /TV technician for help.
• Warning: A shielded-type power cord is required in order to meet FCC emission limits and also to prevent
interference to the nearby radio and television reception. It is essential that only the supplied power cord be used.