ZOWEE TECHNOLOGY SC241BA Smart Wifi Camera User Manual

SHENZHEN ZOWEE TECHNOLOGY CO.,LTD Smart Wifi Camera

User Manual

InstallationProduct Views for SetupStatus LEDMicSpeakerPower InputMicroSD Card SlotReset ButtonLED Status:Red ON : Power upRed & Blue flashing : Ready for connectingBlue : Connected Reset Button:Factory Default : Press and hold for 8 seconds to reset the device to factory default settingsSwitch to AP mode: Press and hold for 3 seconds to switch to AP mode for wireless connectingStep 1: Launch the Smart Wi-Fi Camera APP from your smart phoneStep 2: When you hear “Enter connection mode” from the Camera, or the Red and Blue LED are flashing, click the “+” button at the center. Step 3: Scan QR Code on the bottom of camera. If you’ve tried QR Code but still can not connect the Camera to your home Wi-Fi network, please have a try by using the “AP Mode”.Step 1: Press the Reset button and hold it for 3 seconds, then the Camera will restart and enter to AP Mode.Step 2: When you hear “Enter AP Mode” from the Camera, set your smart phone to connect the Wi-Fi “Smart Cam_XXXX” with default password “admin”.This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.¬Any Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.¬This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular 1) Install APP Aimer Cam+ in your smart phone2) Ensure your smart phone is connecting to your hone Wi-Fi network3) Power up the Smart Wi-Fi Camera Put the Camera close to your Wi-Fi Router during the first installationConnecting the camera to your home Wi-Fi networkCan not Connect the Camera?Step3: Then click on “Lan search” and follow the steps to finish the connecting3RZHU3OXJUSB&DEOHinstallation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:-Reorient or relocate the receiving antenna.-Increase the separation between the equipment and receiver.-Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.-Consult the dealer or an experienced radio/TV technician for help.FCC RegulationQuick Start GuideSC-241AA/BAScan the QR Code to download APP Aimer Cam+.IOS: Android:Step 4: Input the password of camera, the default is “admin”. Shenzhen Zowee Technology Co.,ltdThe device complies with RF specifications when the device used at 2000000 cm form your body.

Navigation menu