Zebra Technologies CAN1120 Access Control Panel User Manual
Zebra Technologies Corporation Access Control Panel
User Manual
Guide Sheet - Access Control
Subject to modifications
Zebra Enterprise Solutions GmbH, Rossfelder Str. 65/5, 74564 Crailsheim, Germany, T: +49 7951 963610, F: +49 7951 963611, www.zebra.com/zes
©2009 ZIH Corp. proveo, Zebra Enterprise Solutions, and all product names and numbers are Zebra trademarks,
and Zebra, and the Zebra head graphic are registered trademarks of ZIH Corp. All rights reserved.
All other trademarks are the property of their respective owners.
06 /2009
CardReader / UserID Card
This guide sheet describes the usage and functionality of the UserID System CardReader
which is installed in the GSE. The usage is very similar on any type of GSE. The CardReader
is necessary for the log-on of a user to a vehicle with a special ID card. The usage of the
GSE equipped with the UserID System is only possible with a valid ID card.
The CardReader is usually visibly installed on the dashboard of the GSE.
1. Successful Access
1. Switch on the ignition – the red LED illuminates. The engine can NOT be started.
2. Swipe the IDCard over the CardReader on the dashboard (see picture)
3. The green LED starts blinking, firstly three times then it will be on permanently. The
engine can be started.
4. Start the engine.
Remark: After successful authentication you have a predefined number of seconds to start
the engine. If the engine is not started within this period of time after applying the card, steps
1 – 4 have to be repeated.
After stopping the engine, it can be restarted within a predefined number of seconds without
having to apply the ID card again. After that time the authentication procedure starts again
2. Denied Access
The access can be denied due to the following possible reasons:
1. Card defective
2. CardReader defective
3. No authorisation / authentication
If the authorisation is missing the red LED is blinking three times and the engine can
not be started.
In case of a denied access please contact your supervisor for clarification.
Access Control
©2009 ZIH Corp. Navis, WhereNet, proveo, Multispectral Solutions, Zebra Enterprise Solutions, and
all product names and numbers are Zebra trademarks, and Zebra, and the Zebra head graphic are
registered trademarks of ZIH Corp. All rights reserved. All other trademarks are the property of their
respective owners.
2
Agency Compliance
FCC Compliance Statement
This device complies with Part 15 rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference
(2) this device must accept any interference which may cause undesired operation
This equipment has been tested and found to comply with the limits for Class B
devices, pursuant to Part 15 of the FCC Rules & Regulations.
Canadian DOC Compliance Statement
This Class B digital apparatus complies with Canadian ICES-003.
Cet appareil numérique de la classe B est conforme à la norme NMB-003 du
Canada.
RF Notice
Any changes or modifications to Zebra Enterprise Solutions (ZES) equipment not
expressly approved by ZES could void the user’s authority to operate the equipment.
EU \ EFTA Compliance
Approved for use in the following countries.
AT BE BG CY CZ DK EE
FI FR DE GR HU IE IT
LV LT LU MT NL PL PT
RO SK SI ES SE GB
IS LI NO CH TR
Important Notice:
This RF device is intended for indoor and
outdoor use in all EU and EFTA countries.