Zebra Rz400 Users Manual Z Series / RZ User Guide

2015-01-26

• Declaration of Conformity
  • Compliance Information
• Contents
• About This Document
  • Who Should Use This Document
  • How This Document Is Organized
  • Contacts
  • Document Conventions
• Introduction
  • External View
  • Printer Media Compartment
  • Control Panel
    • Control Panel Buttons
    • Control Panel Lights
  • Printer Language Modes
    • Firmware Downloads
    • Additional Printer Language Information
• Printer Setup
  • Before You Begin
  • Handling the Printer
    • Unpack and Inspect the Printer
    • Store the Printer
    • Ship the Printer
  • Select a Site for the Printer
    • Select a Surface
    • Provide Proper Operating Conditions
    • Allow Proper Space
    • Provide a Data Source
    • Provide a Power Source
  • Select a Data Communication Interface
    • Data Cables and Wireless Cards
  • Connect the Printer to a Power Source
    • Power Cord Specifications
  • Types of Media
  • Ribbon Overview
    • When to Use Ribbon
    • Coated Side of Ribbon
• Operations
  • Print Modes and Printer Options
    • Print Mode Descriptions and Printer Requirements
    • Media Paths
  • Load Media
    • Beginning Steps for all Print Modes and Printer Options
    • Additional Steps for Tear-Off Mode
    • Additional Steps for Peel-Off Mode (with or without Liner Take-Up)
    • Additional Steps for Cutter or Delayed Cut Mode
    • Additional Steps for Rewind Mode
  • Load Ribbon
    • Remove Used Ribbon
  • Calibrate the Printer
    • Auto Calibration
    • Manual Calibration
  • Adjust Printhead Pressure
• Configuration
  • Setup Mode
    • Enter and Use Setup Mode
    • Exit Setup Mode
  • Change Password-Protected Parameters
    • Default Password Value
    • Disable the Password Protection Feature
  • Print a Configuration Label
  • Print a Network Configuration Label
  • Standard Control Panel Parameters
  • Additional Control Panel Parameters
• Routine Maintenance
  • Replacing Printer Components
    • Ordering Replacement Parts
    • Recycling Printer Components
  • Lubrication
  • Cleaning Schedule and Procedures
    • Clean the Exterior
    • Clean the Printhead and Platen Roller
    • Clean the Media Compartment and Sensors
    • Clean the Cutter Module
  • Routine Maintenance for the Rewind Option
    • Remove Printed Labels or Liner from the Rewind Spindle
    • Adjust Media Alignment for Rewind Option
• Troubleshooting
  • Troubleshooting Checklists
  • LCD Error Messages
  • Print Quality Problems
  • Calibration Problems
  • Communications Problems
  • Ribbon Problems
  • RFID Problems
  • Miscellaneous Printer Problems
  • Printer Diagnostics
    • Power-On Self Test
    • CANCEL Self Test
    • PAUSE Self Test
    • FEED Self Test
    • FEED and PAUSE Self Test
    • Communications Diagnostics Test
    • Sensor Profile
• Specifications
  • General Specifications
  • Printing Specifications
  • Media Specifications
  • Ribbon Specifications
  • Printer Options
• Index