Zebra Airwatch Connector P1058563 003 Users Manual User Guide

2015-01-26

• Contents
• About This Document
  • Who Should Use This Document
  • How This Document Is Organized
  • Document Conventions
• Introduction
  • Overview
  • What the AirWatch Connector Does
  • Supported Printers
  • Supported Operating Systems
• Installation
  • Installing in a Windows Operating System
    • Minimum System Requirements
  • Installation Steps
    • Step 1: Install an AirWatch Server
    • Step 2: Install Software
    • Step 3: Set Up Zebra AirWatch Connector
    • Step 4: Create a Certificate
    • Step 5: Set Up Printers
    • Step 6: Test a Printer
• Configuring Printers with WebLink
  • Configuring Weblink
    • Basic Configuration
    • When a Proxy Server is Part of the Network Configuration
    • When HTTP Authentication is Necessary
    • Additional Firewall Configuration
    • Difference Between Conn1 and Conn2
    • Enable Logging
    • Navigating the Log Output
• Using AirWatch Connector
  • Printer Discovery
  • Organizing Printers
    • Create a Group
    • Add Printers to the Group
    • View the Location Group Dashboard
  • Profiles
    • Create a Profile
    • Manage a Profile
  • Updating Printer Firmware and Files
    • Upload a File
    • Manage a File
  • Checking Printer Status
• Troubleshooting
  • Troubleshooting
    • Installation
    • Using AirWatch
  • SSL/TLS Certificate Errors
  • Other Typical Errors
  • Troubleshooting
  • HTTP Messages
• WebLink Set/Get/Do Commands
  • Introduction to SGD Commands
  • weblink.enable
  • weblink.ip.conn[1|2].authentication.add
  • weblink.ip.conn[1|2].authentication.entries
  • weblink.ip.conn[1|2].authentication.remove
  • weblink.ip.conn[1|2].enable
  • weblink.ip.conn[1|2].location
  • weblink.ip.conn[1|2].maximum_ simultaneous_connections
  • weblink.ip.conn[1|2].proxy
  • weblink.ip.conn[1|2].retry_interval
  • weblink.ip.conn[1|2].test.location
  • weblink.ip.conn[1|2].test.retry_interval
  • weblink.ip.conn[1|2].test.test_on
  • weblink.logging.clear
  • weblink.logging.entries
  • weblink.logging.max_entries
  • weblink.printer_reset_required
  • weblink.restore_defaults