Zentan Technology BHRCS1 TP3 SMART HEART RATE TRANSMITTER (ZT26B) User Manual
Zentan Technology Co., Ltd. TP3 SMART HEART RATE TRANSMITTER (ZT26B)
User Manual
▪ Attach one end of the adjustable elastic strap to the transmitter
▪ Moisten the rubber electrodes of the belt with either water or saliva as shown
▪ Position the transmitter on the chest just below the breastbone,
with the Cardiosport logo the right way up.
▪ Pass the elastic strap around your chest and attach to the other end of the
transmitter.
▪ Adjust the strap to give a close but comfortable fit.
12
CAUTION
RISK OF EXPLOSION IF BATTERY IS REPLACED
BY AN IN CORRECT TYPE.
DISPOSE OF USED BATTERIES ACCORDING
TO THE INSTRUCTIONS
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the
following two conditions:(1) this device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class
B digital device, according to Part 15 of the FCC rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and
on, the user is encouraged to try correct the interference by one or more of the
following measures:
1. Reorient the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into and outlet on a circuit different from that to
which the receiver is connected.
4. Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the
instruction manual.
Warning: A shielded-type power cord is required in order to meet FCC
emission limits and also to prevent interference to the nearby radio and
television reception. It is essential that only the supplied power cord be used.
Use only shielded cables to connect I/O devices to this equipment.
CAUSION: Any changes or modifications not expressly approved by the party
responsible for compliance could void your authority to operate the equipment.
IC statement: This Class B digital apparatus complies with Canadian
ICES-003.Cet appareil numérique de la classe B est conforme à la norme
NMB-003 du Canada.
FCC ID: QSWBHRCS1