Zentan Technology DHRCS1 TP3 Duplex Heart Rate Transmitter(ZT26D) User Manual ZT26D
Zentan Technology Co., Ltd. TP3 Duplex Heart Rate Transmitter(ZT26D) ZT26D
User Manual
產品名稱：TP3 Duplex Heart Rate Transmitter 雙頻(ANT+藍芽)心跳發射器
廠牌：CARDIOSPORT
型號：ZT26D
FCC ID : QSWDHRCS1
▪ Attach one end of the adjustable elastic strap to the transmitter
▪ Moisten the rubber electrodes of the belt with either water or saliva as shown
▪ Position the transmitter on the chest just below the breastbone,
with the Cardiosport logo the right way up.
▪ Pass the elastic strap around your chest and attach to the other end of the
transmitter.
▪ Adjust the strap to give a close but comfortable fit.
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
according to Part 15 of the FCC rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try correct the interference by one or more
of the following measures:
1.Reorient the receiving antenna.
2.Increase the separation between the equipment and receiver.
3.Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.
4.Consult the dealer or an experienced radio/TV technician for help.
Any special accessories needed for compliance must be specified in the instruction manual.
Warning: A shielded-type power cord is required in order to meet FCC emission limits and
also to prevent interference to the nearby radio and television reception. It is essential that
only the supplied power cord be used. Use only shielded cables to connect I/O devices to this
equipment.
CAUSION: Any changes or modifications not expressly approved by the party responsible for
compliance could void your authority to operate the equipment.
Required notices to the User of Canada (RSS)
Radio apparatus shall comply with the requirements to include required notices or statements to
the user of equipment with each unit of equipment model offered for sale.
The required notices are specified in the RSS documents (including RSS-Gen) applicable to the
equipment model. These notices are required to be shown in a conspicuous location in the user
manual for the equipment, or to be displayed on the equipment model. If more than one notice is
required, the equipment model(s) to which each notice pertains should be identified. Suppliers of
radio apparatus shall provide notices and user information in both English and French.
IC statement CAN ICES-3 (B)/NMB-3(B)
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is
subject to the following two conditions: (1) this device may not cause interference, and (2)
this device must accept any interference, including interference that may cause undesired
operation of the device.
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils
radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1)
l'appareil ne doit pas produire de brouillage, et (2) l'utilisateur de l'appareil doit accepter
tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en
compromettre le fonctionnement.
－NCC 警語－
經型式認證合格之低功率射頻電機，非經許可，公司、商號或使用者均不得
擅自變更頻率、加大功率或變更原設計之特性及功能。低功率射頻電機之使
用不得影響飛航安全及干擾合法通信；經發現有干擾現象時，應立即停用，
並改善至無干擾時方得繼續使用。前項合法通信，指依電信法規定作業之無
線電通信。低功率射頻電機須忍受合法通信或工業、科學及醫療用電波輻射
性電機設備之干擾。