Zentan Technology ZT18 STRETCH FABRIC TRANSMITTER User Manual 04
Zentan Technology Co., Ltd. STRETCH FABRIC TRANSMITTER 04
Users Manual
ʳ
ʳ
ʳ
User Manual
ʳ
ʳ
ʳ
ʳ
ʳ
ʳ
ZENTAN TECHNOLOGY CO., LTD.
Product Name:
TX:
Stretch Fabric Transmitter
Model Number:
ZT18
FCC ID: QSWZT18
RX:
Product Name:
combi
Model Number:
ZW61 / ZW62 / ZW63
FCC ID: QSWZT18
FCC Compliance and Advisory Statement
This device complies with Part 15 of the FCC rules. Operation is subject to the following two
conditions:(1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation. This
equipment has been tested and found to comply with the limits for a Class B digital device,
according to Part 15 of the FCC rules (15.21). These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by turning
the equipment off and on, the user is encouraged to try correct the interference by one or more
of the following measures:
1. Reorient the receiving antenna.
2. Increase the separation between the equipment and receiver.
3. Connect the equipment into and outlet on a circuit different from that to which the receiver is
connected.
4. Consult the dealer or an experienced radio/TV technician for help. Any special accessories
needed for
compliance must be specified in the instruction manual.
Warning:
A shielded-type power cord is required in order to meet FCC emission limits and also to
prevent
interference to the nearby radio and television reception. It is essential that only the supplied
power cord
be used. Use only shielded cables to connect I/O devices to this equipment.
CAUSION:
Any changes or modifications not expressly approved by the party responsible for
compliance
could void your authority to operate the equipment.
Note:
Section 15.21 Information to user.
The users manual or instruction manual for an intentional or unintentional radiator shall
caution the user that changes or modifications not expressly approved by the party responsible
for compliance could void the user's authority to operate the equipment. In cases where the
manual is provided only in a form other than paper, such as on a computer disk or over the
Internet, the information required by this section may be included in the manual in that
alternative form, provided the user can reasonably be expected to have the capability to access
information in that form.