Zowee Technology SC241BA Smart Wifi Camera User Manual
SHENZHEN ZOWEE TECHNOLOGY CO.,LTD Smart Wifi Camera
User Manual
Installation
Product Views for Setup
Status LED
Mic
Speaker
Power Input
MicroSD Card Slot
Reset Button
LED Status:
Red ON : Power up
Red & Blue flashing : Ready for connecting
Blue : Connected
Reset Button:
Factory Default : Press and hold for 8 seconds to reset the device to factory
default settings
Switch to AP mode: Press and hold for 3 seconds to switch to AP mode for
wireless connecting
Step 1: Launch the Smart Wi-Fi Camera APP from your smart phone
Step 2: When you hear “Enter connection mode” from the Camera, or the
Red and Blue LED are flashing, click the “+” button at the center.
Step 3: Scan QR Code on the bottom of camera.
If you’ve tried QR Code but still can not connect the Camera to your home
Wi-Fi network, please have a try by using the “AP Mode”.
Step 1: Press the Reset button and hold it for 3 seconds, then the Camera will
restart and enter to AP Mode.
Step 2: When you hear “Enter AP Mode” from the Camera, set your smart
phone to connect the Wi-Fi “Smart Cam_XXXX” with default password
“admin”.
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including
interference that may cause undesired operation.
¬
Any Changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate the
equipment.
¬
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates uses and can radiate radio
frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular
1) Install APP Aimer Cam+ in your smart phone
2) Ensure your smart phone is connecting to your hone Wi-Fi network
3) Power up the Smart Wi-Fi Camera
Put the Camera close to your Wi-Fi Router during the first installation
Connecting the camera to your home Wi-Fi network
Can not Connect the Camera?
Step3: Then click on “Lan search” and follow the steps to finish the
connecting
3RZHU3OXJ
USB
&DEOH
installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or
more of the following measures:
-Reorient or relocate the receiving antenna.
-Increase the separation between the equipment and receiver.
-Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
-Consult the dealer or an experienced radio/TV technician for help.
FCC Regulation
Quick Start Guide
SC-241AA/BA
Scan the QR Code to download APP Aimer Cam+.
IOS: Android:
Step 4: Input the password of camera, the default is “admin”.
Shenzhen Zowee Technology Co.,ltd
The device complies with RF specifications when the device used at
2000000 cm form your body.