dormakaba EAD WRU-100 User Manual Dsc00001

Kaba GmbH Dsc00001

Excerpt from users manual

__________________________________________________________________________________________________________________________________________________________________16 User Manual Bedas 93 20 12/992 InstallationThe applicable rules of safety of electrical equipment must be observedwhen installing components !No modifications are allowed to be made by the user ! Otherwise, thepermission to operate the device is void !Note: This equipment has been tested and found to comply with thelimits for a Class B digital device, pursuant to part 15 of the FCC rules.These limits are designed to provide reasonable protection againstharmful interference in a residential installation. This equipment gene-rates, uses and can radiate radio frequency energy and, if not installedand used in accordance with the instructions,may cause harmful inter-ference to radio communications. However, there is no guarantee thatinterference will not occur in a particular installation. If this equipmentdoes cause harmful interference to radio or television reception, whichcan be determined by turning the equipment off and on, the user isencouraged to try to correct the interference by one or more of the fol-lowing measures:- Reorient or relocate the receiving antenna.- Increase the separation between the equipment and receiver.- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.- Consult the dealer or an experienced radio/TV technician for help.
__________________________________________________________________________________________________________________________________________________________________12/99 User Manual Bedas 93 20 172.1 Power SupplyBefore any device is connected to the supply voltage, it must be checked ifthe line voltage is corresponding with the devices requirements. See typelabel of the device.Devices which are dedicated for installation in dry rooms, e.g. offices, are notallowed to be installed outdoors or in rooms where splashing water mightoccur. Devices which are installed in such areas are not allowed to be con-nected at 230V but must be supplied with 24V voltage.Model Bedas 93 20 shall be installed on the load side of a class2 or class3power source as defined by the National Electric Code (NEC), article 725-2.For proper wiring methods, refer to NEC articles 725-52,-54,-61 and 71.For reducing of electromagnetical interferences the cable type between po-wer supply and device must absolutely be shielded. The shielding must beconnected on both sides to protective earth. In the terminal protective earth isrealized via the cable clamp. Additionally the cable must be lead-in the ferritewhich is deliverd with the device.The ferrite must be installed as near as possible to the device!
__________________________________________________________________________________________________________________________________________________________________12/99 User Manual Bedas 93 20 31conformity with directive 89/336/EWG and 93/68/EWGchecked according to EN 50081-1 and EN 50082-2Additionally for terminal with Legic reader:Contains FCC ID: NVIWRU-100This device complies with Part 15 of the FCC Rules. Operation is subject tothe following two conditions: (1) this device may not cause harmful interfe-rence, and (2) this device must accept any interference received, includinginterference that may cause undesired operation.

Navigation menu