eSky wireless ES610 GPS Tracker User Manual

Download:
Mirror Download [FCC.gov]
Document ID	2492783
Application ID	GyeWGawzwV83HHtLF5L5Mw==
Document Description	User Manual
Short Term Confidential	No
Permanent Confidential	No
Supercede	No
Document Type	User Manual
Display Format	Adobe Acrobat PDF - pdf
Filesize	79.39kB (992368 bits)
Date Submitted	2015-01-07 00:00:00
Date Available	2015-01-07 00:00:00
Creation Date	2014-12-23 11:54:52
Producing Software	Adobe PDF Library 9.0
Document Lastmod	2014-12-23 11:54:55
Document Title	进入我们公司网站首页（ www
Document Creator	Acrobat PDFMaker 9.0 Word 版
Document Author:	微软用户

Suzhou eSkywireless Inc.
ES610 user manual
ES610 user manual
Suzhou eSkywireless Inc.
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
Information to User
This device complies with part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
RF warning
The device has been evaluated to meet general RF exposure requirement. This device should be
installed in where that has no emission source and no metallic object obscures.
RF Exposure Compliance
The antenna(s) used for this transmitter must be installed to provide a separation distance of at
least 20 cm from all persons and must not be co-located or operating in conjunction with any other
antenna or Transmitter.
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
1 PREPARE before INSATLLATION
1.1 Product Display
（image of ES610）
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
1.2 Packaging Inspection
Open the box, check the terminal model is correct and the accessories are complete. Otherwise,
please contact your dealer.
1.3 Install SIM Card
1.3.1 Selection of SIM Card
The ES610 is a GPS/GPRS terminal, and it needs a GSM/GPRS SIM card. please reference dealer’s
opinion to select carrier.
1.3.2 Installation SIM card
Open the terminal cover, and put the metal side of SIM card face down and then fasten the card
slot cover.
1.4 Power On
The terminal standard power supply is 6V-34V. the red line is the positive power supply and the
black line is the negative power supply.
Note:
Please select the negative power line grounding alone.
2 Steps of AT Setting before tests
Start hyper-terminal connection as follows.
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
1)select the comm port of PC through which ES610 is connected with PC, as the follows
2) In Port Settings, change communication speed (bits per second) to 115200bps,
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
3)Final step is the certain AT settings necessary after 1st running of downloaded program.
3.1) Start connection first
3.2) Restart ES610
3.3) After you see the "IIII"as the following picture, start setting.
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
3 INSTALL and OPERATION
3.1 Installation Method
The terminal is GPS positioning products, it is recommended that you follow the instructions to
install.
Note:
1) The following installation order, please do not inverted.
2) During the installation process, please do not supply the terminal.
The terminal installation is divided into hidden installation and open installation.
When the terminal is using special vehicles, hidden installation is recommended. Otherwise, open
installation is chosen. (To avoid thieves’ damage, the installation location should be hidden)
(cigarette lighter)
（OBD）
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
① Battery connector
② Power connector, connecting terminal with the power connector of wire harness, as picture
above.
③ I/O connector, connecting terminal with the I/O connector of wire harness, as picture above.
④ I/O lines
⑤ Power lines, it can connect with cigarette lighter or OBD, as picture above.
3.1.1 Open Installation
The power connecting line we selected is provided by original cigarette lighter cord.
3.1.2 Hidden installation
The power connecting line we selected is provided by original the main power core. And the red
line has a fuse box (3A fuse) which can play a short circuit overcurrent protection role.
3.2 Installation Site
The places that we suggest to install:
① The bottom of the front windshield decorative plates
② Around of front dashboard (epidermis as nonmetallic material)
③ Below the decorative panels of rear windshield
④ Inside the front bumper (should pay attention of water)
⑤ Below the wipers plate (should pay attention of water)
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
3.3 Installation Notes
① Avoid put together with the emission source, for example, reversing radar, anti-theft devices
and other on-board communications equipment.
② As for fixing the terminal, you can bound with ties or stick with wide sponge strength
double-faced adhesive.
③ The terminal has GSM antenna and GPS antenna，so the installation should ensure that the
ES610face up (that is GPS toward the sky). Besides, there is no on-metallic object that obscures
above the terminal.
④ If your car’s windshield pasted with metal insulation layer or the heating layer, GPS receiving
signal will be weakened, and it may cause GPS work abnormal. So please change the location you
installed the terminal.
http://www.eskywireless.com
Suzhou eSkywireless Inc.
ES610 user manual
Federal Communication Commission Interference Statement
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1)
This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential installation. This equipment generates,
uses and can radiate radio frequency energy and, if not installed and used in accordance with
the instructions, may cause harmful interference to radio communications. However, there is
no guarantee that interference will not occur in a particular installation. If this equipment does
cause harmful interference to radio or television reception, which can be determined by
turning the equipment off and on, the user is encouraged to try to correct the interference by
one of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
- Consult the dealer or an experienced radio/TV technician for help.
FCC Caution: Any changes or modifications not expressly approved by the party responsible for
compliance could void the user's authority to operate this equipment.
This transmitter must not be co-located or operating in conjunction with any other antenna or
transmitter.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled
environment.
http://www.eskywireless.com

---

Source Exif Data:

File Type                       : PDF
File Type Extension             : pdf
MIME Type                       : application/pdf
PDF Version                     : 1.5
Linearized                      : Yes
Author                          : 微软用户
Create Date                     : 2014:12:23 11:54:52+08:00
Modify Date                     : 2014:12:23 11:54:55+08:00
Tagged PDF                      : Yes
XMP Toolkit                     : Adobe XMP Core 4.2.1-c041 52.342996, 2008/05/07-20:48:00
Metadata Date                   : 2014:12:23 11:54:55+08:00
Creator Tool                    : Acrobat PDFMaker 9.0 Word 版
Document ID                     : uuid:16417e91-dff2-45e0-bd90-0eaac65c391c
Instance ID                     : uuid:10a1ce46-9d0d-4f98-9640-b228e68b5bfc
Subject                         : 7
Format                          : application/pdf
Title                           : 进入我们公司网站首页（ www
Creator                         : 微软用户
Producer                        : Adobe PDF Library 9.0
Source Modified                 : D:20141223034948
Company                         : 微软中国
KSO Product Build Ver           : 2052-6.6.0.2877
Page Layout                     : OneColumn
Page Count                      : 10

EXIF Metadata provided by EXIF.tools