Introduction
This guide provides instructions for setting up and connecting the esinkin Bluetooth Audio Receiver. For support, esinkin can be contacted at esk@esinkin.com.
Setup and Connection
Bluetooth Pairing
- Ensure the esinkin Bluetooth Audio Receiver is powered on.
- On your mobile device (e.g., smartphone, tablet), navigate to the Bluetooth settings.
- Search for available devices and select "esinkin" from the list.
- Once connected, the device will indicate successful pairing, and audio can be streamed wirelessly.
Audio Output Connections
- Connect the esinkin Bluetooth Audio Receiver (1) to a power source.
- Connect the audio output of the receiver (2) to your audio system (e.g., speakers, amplifier) using either:
- RCA cables: Connect the red and white RCA plugs from the receiver to the corresponding red and white RCA input jacks on your audio system.
- AUX (3.5mm) cable: Connect the 3.5mm stereo plug from the receiver to the AUX input jack on your audio system.
- Ensure all connections are secure before use.
Regulatory Information
FCC Statement
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- Reorient or relocate the receiving antenna.
- Increase the separation between the equipment and receiver.
- Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.
IC Statement
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic Development Canada's licence-exempt RSS(s). Operation is subject to the following two conditions: (1) This device may not cause interference. (2) This device must accept any interference, including interference that may cause undesired operation of the device.
L'émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d'Innovation, Sciences et Développement économique Canada applicables aux appareils radio exempts de licence. L'exploitation est autorisée aux deux conditions suivantes : (1) L'appareil ne doit pas produire de brouillage; (2) L'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d'en compromettre le fonctionnement.
