ALPS ALPINE I61M0 Immobilizer base station User Manual 05
Alps Electric Co., Ltd. Immobilizer base station 05
05 User Manual
The connector is arran
g
ed as shown in the fi
g
ure below.
Terminal No. I/O
1I
2I
3 I/O
4I
5-
6I
7-
8I
Since this device is always used with vehicle, it is not sold to general end users separately.
Therefore there is no user manual of this device by alone.
The following should be displayed in the user manual of the vehicle
This device complies with part 15 of the FCC Rules. Operation is subject to the
following two conditions: (1) This device may not cause harmful interference,
and (2) this device must accept any interference received, including interference
that may cause undesired operation.
FCC CAUTION
Changes or modifications not expressly approved by the party responsible for
compliance could void the user’s authority to operate the equipment.
DC5~16V
Operation of frequency 125kHz
Operating voltage DC5~16V(Inner:DC 5V)
Operating temperature
range
-40~+85 degree C
MAX 0.7mA(@12V 25℃) at standby
Weight 0.043kg
Consumption current
spec
MAX 150mA(@12V 25℃) at operation
DC12V
Range of voltage
Consumption current Under 0.7mA(Standby current)
W69xL63xH54(mm)
Size
AC/DC Supply
User Manual
GND
-
LED
It communicates with IC used both as Transponder and Passive RKE
through LF ANT(Z axis) of immobi-key, and operates as ANT to exchange
communication data depending on community signal with BCM.
The immobilizer antenna communicates with the transponder in the immobi -
key when the it is inserted, and receives the code of the key. The immobilizer
is used with key cylinder by inserting the immobi-key as shown in figure.
Product name : Immobilizer base station
Type : I61M0
Terminal Name
LEDG
SCI
SCL
VCC
-
immobi-key immobilizer anntena with
key cylinder
key cylinder
immobilizer anntena