MeiDong Acoustics E7 Bluetooth earphone User Manual E7 NFC Joe
Shenzhen MeiDong Acoustics Co., LTD Bluetooth earphone E7 NFC Joe
User Manual
User’s Guide E7 FCC ID:2AB5T-E7 Contents 1. Introduction 2. Battery Precautions 3. Getting Started 4. Installation Operation 5. Cable Connection 6. Bluetooth Connection 7. NFC Connection 8. Function Guidance 9. LED Display Status 10. Battery Charging 11. Product care Please read the following safety warnings and precaution before using your device. -1- Specification E7 Load impedance: 32Ω S/N: ≥90dB Frequency range: 22Hz-20KHz Power supply: Lithium battery or USB cable Audio source: iPhone, iPad, Smartphone, Notebook, MP3, MP4, etc Function spec: Bluetooth, Microphone, Active Noise Cancelling Size: 166x92x181mm Operating range up to 20 meters. 1. Introduction Thank you for purchasing our Active Noise Cancelling Bluetooth headphone: E7. This device can be easily connected with Smartphone, tablet PC and other devices via Bluetooth during your traveling and daily usage. It will bring you an easy lifestyle. -2- 2. Battery Precautions The device can be powered by a built-in rechargeable lithium battery. Please charge the battery for at least 8 hours before your first use of device. If the device is not used for a long period of time, the battery may be out of power. Please charge the battery. Rechargeable batteries are only to be charged under adult supervision. Use only the supplied micro USB cable to recharge the battery. Improper charging may damage the battery and the device. Do not attempt to open the rechargeable battery or battery pack. There are no serviceable parts inside. Should a battery leak, the device may become damaged. Clean the battery compartment immediately, avoid touching your skin. Keep the battery out of reach of children. If swallowed, consult a physician immediately. Avoid storing the battery in extremely hot or cold environment. A device with a hot or cold battery may not work temporarily, even when the battery is fully charged. Do not dispose batteries in a fire as they may explode. Batteries may also explode if damaged. Please dispose them according to local regulation. Do not dispose them as household waste. -3- 3. Getting Started Volume Down/Previous Volume Up/Next Play/Pause, Answer call NFC AUX IN MIC OFF Noise cancelling Bluetooth USB for Charging -4- 4. Installation Operation Step . 1 Step . 2 put on this headphone Adjustable length Step . 3 It can be adjusted To be fit by twisting the left and right ear muffs. Adjustable angle -5- 5. Cable Connection USB for power Cable for audio 6. Bluetooth Connection Pairing headphone to your Smart device (Smart device should be within 10 meters of this headphone). 1. Activate pairing mode on headphone by turn the switch to “BT” .The LED will flash in blue. 2. Turn on Bluetooth function of your device, (refer to the device owner’s manual to locate Bluetooth function). 3. Select “Search” or “Discover” devices. 4. Select “E7”. 5. If requested, type the password or PIN 0000 6. Press the Enter key. -6- After completing the steps above, a message on your Smart device will appear confirming that your device is now paired/ connected. In case of unsuccessful pairing, turn off it and restart, then do as steps above. If the Bluetooth on your smart device remains open, when you restart the headphone, the Bluetooth will be connected automatically. 7. NFC Connection NFC: Near Field Communication, is a set of standard for wireless devices to establish radio communication with each other by touching them together or bringing them into close proximity, usually within a few centimeters. Please activate the NFC function of your smart device and put the device close to the Bluetooth headphone. Your smart device will ask you if you want to pair with the headphone, choose Yes or OK to complete the pairing process. -7- 8. Function Guidance Play music from your Smart device Button Operation Function Long Press Volume up Short Press Next song Long Press Volume down Short Press Previous song Short Press Play/Pause, Answer/End a call. Long press Ready for pairing 9. LED Display Status LED Display Right Light Blue Light indication Flash Power ON Paired Stay Solid Noise cancelling White Left Light Red Charging in process OFF Fully charged -8- 10. Battery Charging The device has a rechargeable battery. This can be charged by USB cable connected with your computer. When it’s charging, the light below the left button will turn to red. After charged, the device can be used without the power connection. Charge the device again when you hear the headphone make successive beep sound. 11. Product care This device is designed to be light, compact and durable. As an electronic device it must be treated carefully. Putting unnecessary pressure on it or striking the device against other objects may cause damage. To avoid damage to your device, please Do not drop, crush, bend or apply excessive force to the device. Do not expose your device to moisture, extreme or prolonged heat, cold, humidity, or other adverse conditions. Avoid storing it in damp, humid or wet places, as it is not waterproof. Clean the unit with a soft cloth or damp chamois leather. Never use solvents. The Unit can only be opened by qualified personnel. This device contains magnets. Keep magnetic field sensitive products such as credit cards and video screen away from this device to avoid damage or malfunction. -9- NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: —Reorient or relocate the receiving antenna. —Increase the separation between the equipment and receiver. —Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. —Consult the dealer or an experienced radio/TV technician for help. This device complies with part 15 of the FCC rules. Operation is subject to the following two conditions: (1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. Changes or modifications to this unit not expressly approved by the party responsible for compliance could void the user's authority to operate the equipment.
Source Exif Data:
File Type : PDF File Type Extension : pdf MIME Type : application/pdf PDF Version : 1.4 Linearized : No XMP Toolkit : Adobe XMP Core 5.3-c011 66.145661, 2012/02/06-14:56:27 Format : application/pdf Title : E7 说明书NFC版(Joe) Metadata Date : 2015:03:24 16:03:24+08:00 Modify Date : 2015:03:24 16:03:24+08:00 Create Date : 2015:03:24 16:02:06+08:00 Creator Tool : Adobe Illustrator CS6 (Windows) Thumbnail Width : 256 Thumbnail Height : 56 Thumbnail Format : JPEG Thumbnail Image : (Binary data 4673 bytes, use -b option to extract) Instance ID : uuid:ce200770-669d-4168-a352-05e677d6d141 Document ID : xmp.did:EFBFA3D0EBD1E411AAFBCEB2BE2F7808 Original Document ID : uuid:5D20892493BFDB11914A8590D31508C8 Rendition Class : proof:pdf Derived From Instance ID : uuid:63764e77-b7ab-4e49-9ff0-2eb554502690 Derived From Document ID : xmp.did:8EDB1AFF80A7E411A750D42192F18432 Derived From Original Document ID: uuid:5D20892493BFDB11914A8590D31508C8 Derived From Rendition Class : default History Action : saved, saved History Instance ID : xmp.iid:63E91909085BE211A6D2D925D02DC0D5, xmp.iid:EFBFA3D0EBD1E411AAFBCEB2BE2F7808 History When : 2013:01:10 17:28:04+08:00, 2015:03:24 16:02:06+08:00 History Software Agent : Adobe Illustrator CS5, Adobe Illustrator CS6 (Windows) History Changed : /, / Manifest Link Form : EmbedByReference Manifest Reference File Path : C:\Users\MG006\Desktop\DSC_6786.png Startup Profile : Print Has Visible Overprint : True Has Visible Transparency : True N Pages : 1 Max Page Size W : 80.000285 Max Page Size H : 110.000176 Max Page Size Unit : Millimeters Font Name : Arial-Black, ArialMT, MicrosoftNewTaiLue, MicrosoftNewTaiLue-Bold, MicrosoftPhagsPa-Bold, Myriad-Roman, SimHei, AdobeSongStd-Light Font Family : Arial Black, Arial MT, Microsoft New Tai Lue, Microsoft New Tai Lue, Microsoft PhagsPa, Myriad, 黑体, Adobe 宋体 Std Font Face : Regular, Regular, Regular, Bold, Bold, Roman, Regular, L Font Type : Open Type, Type 1, Open Type, Open Type, Open Type, Type 1, Open Type, Open Type Font Version : Version 5.06, 001.001, Version 5.90, Version 5.90, Version 5.90, 001.001, Version 5.01, Version 5.017;PS 5.002;hotconv 1.0.67;makeotf.lib2.5.33168 Font Composite : False, False, False, False, False, False, False, False Font File Name : ariblk.ttf, _A______.PFB; _A______.PFM, ntailu.ttf, ntailub.ttf, phagspab.ttf, wmr_____.pfb; wmr_____.pfm, simhei.ttf, AdobeSongStd-Light.otf Plate Names : Cyan, Magenta, Yellow, Black Swatch Groups Colorants Tint : 100.000000 Swatch Groups Group Name : 鲜艳 Swatch Groups Group Type : 1 Swatch Groups Colorants Swatch Name: C=60 M=90 Y=0 K=0 Swatch Groups Colorants Mode : CMYK Swatch Groups Colorants Type : PROCESS Swatch Groups Colorants Cyan : 60.000002 Swatch Groups Colorants Magenta : 90.000004 Swatch Groups Colorants Yellow : 0.003099 Swatch Groups Colorants Black : 0.003099 Producer : Adobe PDF library 10.01 Page Count : 11 Creator : Adobe Illustrator CS6 (Windows)EXIF Metadata provided by EXIF.tools